Separate names with a comma.
Some features disabled for guests. Register Today.
If it were moisture would I see the same result using an end mill?
No because I want the flat depth look for this particular project.
Birch plywood trying to use the v bit because the letters are too small for an end mill.
Hello all I am trying to run a vcarve toolpath on plywood and it is coming out very rough. I have it set to a flat bottom depth of .04 and have...
Thank you for the video. I will be using the probe turned upside down
Thank you very much. Absolutely the way I understood it. I just wanted to reassurance.
I just added a vacuum table and meant to start setting my zero on the Z axis at the table top instead of the material top. My question is what...
How do I change the GRBL setting to allow a higher max feed rate on my X axis? I am only cutting foam and can run much higher than it is currently...
Please do and message me when it is up.
Well just read through those two very informative post and mind is blown at the moment. lol will read them again and digest Has anyone seen a...
Hello and sorry if this is a pretty bad question lol how do you set the x,y,z origins to engrave with a laser on your CNC and then switch to cut...
Yep that was it..:,man what a crazy difference the direction made. Doesn’t make sense to me
Ok I need help again...lol have been running ok but I had a computer crash and since I got it back online I swear the machine is running the...
I had very recently just sprayed the teflon spray which was a second time in a short period so it should be lubed well. how far do I turn the...
Do you mean dial it down in the settings on the openbuilds control software or in my tool path? also I had to replace another thrust bearing to...
Here is the video and thank you
well it ran for most the day and locked up again. In the topside of the y axis rail I can only seem to get the front and back wheels closest to...
Ok , so i replaced the thrust bearings as they were a bit beat up. It is now running BUT....the wheel I thought was ruined seems to be bearing all...
took the wheel off and not bad actually and the arm still wont roll foward so something else is causing it to lock up....no idea.... any...
its upper thinking about toking it off and swapping a lower wheel to the top side and leaving the lower side void until I can get a replacement....
