Separate names with a comma.
Some features disabled for guests. Register Today.
Update: I set Estlcam feed rate to 2480 mm/min. But this was terribly lethargic. So I adjusted the CONTROL slider to 150%. Absolutely no...
Hi again. Here's my GRBL file $0=10 ; Step pulse time, microseconds $1=255 ; Step idle delay, milliseconds $2=0 ; Step pulse invert, mask...
Hi Peter, Thanks - will do as soon as I finish my wake-up coffee and get to the shed. Duncan
Hi, Any idea why my Workbee is so slow? I,very adjusted the GRBL setting to increase the X and Y max speed, but anything over 4000 makes the...
First, allow me to congratulate you guys for a great upgrade. I am really finding the job time summary useful. No more guesswork. However, may...
Ah ha! I'll take a closer look today. That would certainly explain it. Is there anything you DON'T have good advice for? Haha. Regards, Duncan
Hi, Any idea why the little magnet (part of the OB probe) has lost ALL magnetism? Weird.
Hi Banjopete, (Do you play banjo, BYW?) Well, I took your advice, and cut the 2nd side of the airframe as follows: [ATTACH] Six passes, but at...
Hi Banjopete, I'm cutting half sheets of 19mm ply in order to get a one-piece fuselage airframe (well, actually two pieces, because I join the...
Hi, My question was related to where to physically attach the Z-stop so that its body clears the wheels, but the roller at the end of the switch...
Since I routinely cut 19mm (3/4") plywood, there is precious little clearance between the bit and the work surface. So little, in fact, that I...
I had crimped ferules on the ends of all the wires, and found that quite a few of them were making poor contact. Lesson: ferules do not work on...
Hi, I have just recabled my Workbee because I stupidly cut my cables too short and couldn't move the Blackbox controller. Both the Y and Z axes...
Hi, I have to disagree with the general flow of replies you've received so far. I routinely cut 19mm (3/4") plywood in a single pass. This is...
Hi Peter, That's brilliant. Thank you. Eagerly awaiting the upcoming release. I'll beta test it for you if you wish. Duncan
Thanks mate. But I'm not into programming anything. My days of fiddling with code are long past. However, I'm more interested in an "elapsed...
Hi, I think I've mentioned this before, but just in case it was missed: Is there a way for the CONTROL software to monitor the length of jobs? I...
Hi, Thank you. Excellent starting point for me. And nice work, BTW...
Hi, I need to engrave each of my 56 aluminum (6061-T6) parts (otherwise, I'll never be able to tell them apart). So: (1) Any advice on router bit...
Hi, You mean in the serial console?