Separate names with a comma.
Some features disabled for guests. Register Today.
Hi, After cutting a whole airplane (56 parts) without a hitch, GRBL has suddenly started throwing up an error at random times. This is the error....
Thank you,
Hi, I've searched this forum, but most of the post dealing with engraving seem to be about deeper carving that I am wanting to do. Basically, I...
The gantry stopped in its tracks, with a loud screaming noise - as though it had run into something, but there is nothing for it to hit. As...
Hi, I've attached a short video of my Workbee homing issue. Any help would be appreciated. Regards[MEDIA]
Hi, The machine is dialed in and cutting! First job was to cut 36 foam wing ribs. 65mm/sec, 20mm DOC, 3.175mm upcut bit, 8600 RPM (lowest Makita...
Hi, I've ordered my 2" set, so given the tardiness of the US postal service for overseas destinations, it'll probably be here in a month or so....
Hi, My first job on my brand spanking new Workbee 1515 has been to level my spoilboard. In my opinion this is an absolute must-do for every new...
Hi, My switches are a different shape/size to the one showed in the build video. I've managed to get mine pretty darn close, but my soldering is...
I also have one of the OB XYZ touch plates, but there's no room on top of the plywood to deploy it...
Hi, As you can see from the attached photo, I'd like to have the Z-axis stop just shy of the Z-axis end plate. But I can't figure out where or...
I've just dismantled the ring, and I can see the inscription of +ve and -ve on the ring itself. Problem solved. Thank you.
Hi, OK - is there any way of determining what the polarity of the LED ring plug is? I don't see any markings? It seems to be a regular two-pin plug.
To elaborate: The LED ring has a green plug on it, with two screw-in connectors. One wire goes into each. After traversing the mysteries of the...
Hi, It came with a wire. Two strands. Which strand gets connected to which terminal on the power supply? I've watched the video of how to wire...
Hi, I don't want to blow up my shiny new Workbee, so I'm asking what might be an obvious question before I do. I understand that the light ring...
Hi, From what I gather, this was a limit within GRBL, which has (since v1.1h) been remedied. You will need to check the GRBL docs for details....
Hi, OK, I'm a little confused. I would have thought that putting limit switches on the X-min and Y-min positions would allow me to zero X and Y...
Hi, Thank you both for your comprehensive replies. Peter, it is entirely possible that I committed one of the cardinal sins you mentioned. Your...
Good to know. Three questions, however. 1. What are the benefits of using the Estlcam controller, and will this replace the CONTROL interface...