Separate names with a comma.
Some features disabled for guests. Register Today.
Yes I figured it out. Thank you. The issue was setting PD143 and PD144 on the VFD. It thought I had a 4 pole spindle instead of two pole thereby...
Ohhh. That kinda explains it then. I didn't know that. Thanks for all the help. I'll have to figure out what to use the coolant and relay for then...
Ok. So I was able to get it figured out I think. PD143 was set to 4 and PD144 was set to 1440. I changed them to 2 and 3000 as described in...
Have you figure all of this out? I'm setting mine up right now and having issues as well. I'll put in S8000 and the VFD will only show like 4000.
I'll have to check that. I didn't even know that was a setting.
So I have PD001 and PD002 set to 1 and PD070 set to 0. When I input command M5 the spindle does shut off, or at least it stops spinning.
As I stated above, I tried both $31=0 and $31=8000. They both produced different results. $31=0 produced the higher rpm of 4000 when sending S8000.
I calibrated that the other day. Unless it somehow changed during one of the firmware flashes I've done since I calibrated it, it should still be...
So I finally got my shielded wire in the other day for my spindle so I was able to get around to wiring it up. I'm having some issues due to some...
Do you know how to add M8/M9 commands in Aspire so that the post processor automatically adds it to the code?
What post processor do you use for this control software from Aspire? I searched and saw a few people say basic Grbl but nothing specific. I saw...
****, it even states it right at the top of that page lol. I thought I saw that page from another users post but I guess not. Thanks for the help!
So basically it's only going to send command signals to the VFD and water cooler, not actually power them? I just want to make sure I understand...
So after looking around quite a bit at Shapeoko and X-Carve etc for my first CNC. I've decided that it's a better financial option to build my own...