Separate names with a comma.
Some features disabled for guests. Register Today.
Something else to add to the "what went wrong and how did we fix it the last time" book.
This has been a joint project with my 21 year old grandson. After looking at the cut plastic he thought the edge was slightly beveled. Quick check...
Setup was same as 2 months ago. When the first piece started to go belly up we thought " dull bit" and changed it. It's not an "O" flute but i've...
It is definitely shattering. Upper cutout was done 2 months ago with the same parameters and working correctly, chips and no melting. Checked...
Tried to say I aborted the program on the left or I'm sure it would look as bad as on the right.
Hopefully someone has run into this problem befor. Machine is a generic 3018 with mod's. Material is 6mm cast acrylic, parameters are; feed rate...
Thanks Peter; I'm playing with Vetric 2D cutout free version and it seems great. One question, which of the 6 million toolpath options do you...
As stated, is there a CAD program with a built in G-code translator?? I use DesignCAD 3D to layout my designs then convert to .dxf and send it to...
Thank you.
Did a search and couldn't find anything. When I get an error message on openbuild controller it pops up for about a second, way too fast to read....
I have a variable speed spindle motor (pot controlled not PWM) connected to grd and pin 13 on the UNO. Is there a way to post just M3 on the open...
Thanks to all who responded. Switching the leads, ground on the - pin and the + pins to the arduino did indeed fix the problem. That being the...
Pic is under Cnc builds/unknown terms. Both Giarc and Kyo said + pin is 5v . I did just notice that the enable + pin has 5v though the neg. is not...
The drawing I got off this forum said attach the DIR and PUL plus pins to 5v and the negative to the Arduino outputs so their were no changes to...
Switched to openbuilds control..no change verified all the connections again. Can I ground the PUL pin directly on the driver without damaging...
Thanks for responding[ATTACH] Drivers have power. Photo shows test circuit attached. Can control the pulse with the pot and direction by pressing...
UNO doesn't require the CH340SER driver like Nano does it??
Hopefully this is the proper place for this, please feel free to move. Have been beating on this problem for days and were going nuts. There...
Found an article under "Electronics" that says don't worry about it unless your large scale commercial. Guess I'll go with that.
I'm using Candle with grbl1.1h installed. Got distracted yesterday, like everyone else, will do some more investigating today. The drivers are set...
