Separate names with a comma.
Some features disabled for guests. Register Today.
No version markings on mine so I must have received the old version. Just wanted to verify what was discussed earlier because it wasn't in line...
I ordered a new switch to have as a back-up (received 10July2023) and I checked continuity between the area around the screw and the ground pin....
My switches were purchased in 2020, so if it has been resolved, awesome! I fixed mine with some additional plastic washers and then verified with...
Recently ran into this issue after upgrading my workbee to linear rails. The spindle is now earthed to the whole machine frame since there are no...
I noticed something the other day running version 1.0.282. After leaving the program open on my computer for a day but inactive, it became...
Thanks, I read through that last night, I wasn't aware M3 was a proportional signal. I was thinking the SXXX command was the proportional part of...
I currently have the relay in the Blackbox set to enable with the M3/M5 commands. I noticed that it will only close the relay if SXXX is set...
I have the YL-620 VFD and a 1.5kW spindle. I just re-wired my cable today to only have the shield grounded at the VFD. I dont have any...
I have checked continuity of all 4 wires to the chassis of the Z carriage and there is nothing there. I just find it odd that everything seems to...
Now to solve my vfd emi bleed problems.. Can you explain more of what you are fighting? I have been pulling my hair out with the Interface and...
To all those that are having issues with USB recognition. Ensure that it is in fact formatting to FAT32. This format is not supported by windows...
Thanks Peter, I figured it was something along these lines. You are correct, on other jobs it is a non-issue, just found it interesting for that...
I ran into a minor issue last night using version 274. Not sure when the pop-up got added to indicate run time, however, that popped up with...
Thanks Peter, just verifying it will work for what I need. Though i already placed my order, so I was putting the cart before the horse.
Through the Interface, is there a way to manually zero the x and Y axis then just use a probe to set Z? I only use a Z probe as most of the time...
This all makes sense to me, i have a jumper wire from ground to fwd rather than running it through the relay. The PWM output from blackbox then...
Minor issue i noted when setting up a new Z probe. The first time you update the thickness for a new probe, the software still references the old...
Correct, i highly doubt i am getting the rated flow from that. Not sure on how little flow is needed for the spindle, i don't think it takes...
I am not in a 220V country, i ordered a 220V spindle just to have lower current as well as well as future expansion possibilities. They then sent...
Thanks for your help on this! I will likely just remove the relay from the equation and run the pump any time my system is powered up. I'm not a...