Separate names with a comma.
Some features disabled for guests. Register Today.
What are you using the relay to control? I am just sending the 0-10V signal to control speed for my spindle and it appears to be working fine. I...
I think what the OP is looking for is a way to adjust the default command from the dropdown in the Control software to be something other than...
Peter, sorry for the delay in getting to this. I did some tests tonight with both OpenBuilds Control as well as UGS. I was able to narrow it...
Looking at the g-code, this appears to have fixed the issue. I have not run any of the files to confirm there are no new issues. Thank you for...
I use the coolant commands to control the relay in the controller which I have hooked up to a 240v pond pump for my water cooled spindle as well...
I copied it to a text file but I seem to have lost that. The last item it shows is the M5 command with no other errors shown. Just the normal...
I noticed that when the post processor for Fusion 360 outputs multiple files for different tools, the spindle speed up delay is missing on all but...
I have had this issue a few times where at the end of a carve it does not fully finish the G-code. The M5 command gets sent, however, the machine...
This all makes sense now. Thank you for your reply!
So is the MCS cleared out after every power cycle requiring a re-homing and re-setting of MCS each time? I understand that at power up the...
Not sure if this is intended behavior or not, but when I turn on my Blackbox controller and start up Control, the position is displayed as...