Separate names with a comma.
Some features disabled for guests. Register Today.
I got it to work. Now just need to figure out what I did.
OK so before I ran the GCode in Control, I ran $32=1, Verified my Feed and Tool were both at 100% Hit Run Job. The Machine starts moving and the...
OK will check that out later today.
OK Manual process got it. I use Vetric Laser Plugin, so I would assume it would add these $32 commands to the gcode, but will have to investigate...
I just got the OPTLaser All setup. Yes also went though all the documentation but its still seeming unclear (outside of documents, and forum...
I still think its a worthy look into. Seems no real progress since 2021 for Auto-Level. How can we help?
Its interesting you say that when reading though the forums I believe you have a comment something to the likes of "Do note: CONTROL is aimed at...
Does anyone have any decent Auto Leveling Macro? - In some cases some of my sheets of wood are warped hoping to find a macro that could help with...
Can you run Macros on the Interface?
Yes Thanks for your help! Now I need to finish this large order! -Posted in the interfaces Forum about a Slave mode for Control allowing interface...
It seems it would be a very nice feature to have a slave mode allowing someone to jog the machine while at the machine and still using the Control...
Re-Calibrated Z using wizard and it works good now...
OK so now the next issue. The Z during cuts does not seem to be lowering very much. IE: Making stars with a 90 deg 1/4 bit. When zeroed it barely...
**** stupid... no I did not. Did that and boom seems to be ok so far. Might I suggest a workspace setup Wizard?
OK so I put the $3 back to normal. Jogging is going the direction I am wanting it to go. Homing is working as well. Check size is still trying...
Thanks for the clarification With regard to speed, I believe one of the topics I was reading was talking about speed and the adjustment of the...
Sorry I take a minor offense to the "gotta read that Wiki" comment as I did attempt it multiple times. This is why I am here asking questions. Im...
Yes I Did do a backup of the config, have not tried to restore, kind of nervous too now. Yes the origin is set correctly. How about the travel...
Ok now when I inverse $3 (X and Y) the jog buttons do not align with what direction I am trying to go. Facing my Bed, my start point is Bottom...
OK so with #3, I Unplugged the interface and it did not freak out. Thats a bummer as it would be nice to use the Jogging, start job, probing...
