Separate names with a comma.
Some features disabled for guests. Register Today.
This is a good one to print. Not too hard to pull off and it really showcases the properties of the filament. Printed a few of these and the kids...
I'll second the 'no buildtak' warning. On another machine about a year ago I tried printing Ninjaflex without much success due primarily to the...
Ooh! I was eyeballing AK Eric's nice fan duct and was going to work on a bracket to adapt to the rear plate for us regular E3D users, but you beat...
That is a nice print! I cannot wait to get mine all dialed in. Time seems to be my scarcest commodity. That and every time I sit down I see...
Nearly complete! The printer is essentially done at this point, but I am having a bit of a hiccup. I am able to move X, Y & Z independently using...
Nope. You were not being overly cautious! I had an old tap set from Harbor freight. It was super cheap and I was overly aggressive. Broke it off...
Nice! that sounds like a vast improvement. With BuildTak I have had to develop different techniques in order to preserve the rather fragile...
I had never heard of Print Bite. I see it is from the same folks that make the Flex3Drive. Looks excellent, if it lives up to the description on...
Well, proof is in the pudding. I have another printer I built that uses a single Z screw to drive the X gantry on two 8mm smooth rods. When the...
I guess it would depend on how bad. The ones I ordered were shipped with just bubble wrap around them stuffed into a bag. Of course, one was bent....
That makes sense! On another build I used a mechanical relay with e flyback diode and it has been in service for about 2.5 years and that printer...
Very interesting! I have heard from different folks all around that Simplify3D was a good investment and netted an immediate improvement in...
Yeah, I saw that. It is funny to have an idea I thought was so original and innovative one minute, just to find out a few days later its been...
Yep. I am raising the Z height to 18" for starters. I'll begin with a bowden single extruder, but plan to change it over to direct drive in order...
I just wanted to say, as many have before, thank you to everyone that has contributed to the development and refinement of this project! I found...
