Separate names with a comma.
Some features disabled for guests. Register Today.
I finally had time to play with this & can report the same behavior on both my WorkBee and Shapeoko. With soft limits enabled, continuous jogging...
Yeah, I know better. I must not have been connected. I did connect & grblParams.$20 = 1, as it should. I'm trying to finish a big job on the...
Maybe something... mine is not "1", it's Undefined. see attached.
Home and tested. With soft limits on it acts exactly as it did before & won't continuous jog. I confirmed soft limits were on & experienced the...
I had soft limits on. I homed first, then continuous jogged about 1/3 of the way down the Y axis & stopped. When I tried again I got the error....
I just realized that the settings I sent were with soft limits off... I turned them off so I could jog around the machine. So, everything above is...
$0=10 ;Step pulse time, microseconds $1=255 ;Step idle delay, milliseconds $2=0 ;Step pulse invert, mask $3=5 ;Step direction invert, mask $4=1...
I think I'm going to run Xtension limit switches all the way around my machine. I also wondered if there's a wiring diagram, didn't find one, so...
Peter - I tried V1.0.202 with the fix for this & it doesn't seem to be working. Screenshot attached. I homed first, then continuous jogged about...
I'll add hard limits on the other ends. So, no rush. But if you fix it I'm going to run my Shapeoko with CONTROL until my Workbee is ready :) Thanks!
I said I'd post my idea if it worked and I think it did. See attached. I have the luxury of access to a 3000W fiber laser at my work so I made...
Spark Concepts (Spark Concepts), not SparkFun. I asked for motor specs. And yes, I'll record & post the sound. Thanks!
I don't believe they're yours; they came as part of a kit I bought through Spark Concepts. I'm going to ask for the specs & will probably post...
Sweet - thanks! FYI - when I found CONTROL a few weeks ago (& loved it) I tried it with my Shapeoko. It worked, less a few settings that needed...
Additional info... each motor seems to sound a little different. I started disconnecting them one by one, and with two disconnected the sound was...
I've got my Workbee 1515 up & running. I'm using BlackBox & NEMA 23 high torque motors. Everything seems to be moving normally but the motors are...
My max travel settings are appropriate for my machine and I'm well within them when continuous jogging. Shouldn't it work?
With soft limits enabled, continuous jogging creates an error about exceeding the limits. See below. Is there a way to eliminate this error?
In the assembly manual the instructions say to post the limit switch on the top of the left Y axis C-beam, as shown on the right in the attached...
Thanks - I like this! I have access to a lathe at work & might be able to make something there. I'm also considering using 8mm dowels & couplers...