Separate names with a comma.
Some features disabled for guests. Register Today.
Oops! Sorry, I am using the OpenBuilds probe that came with Control in the lower left corner. I follow the directions that show when you click on...
I am using Window 11 and Vectric X-carve desktop and OpenBuilds control as my sender. When in Vectric I have the model centered on the work...
Yes, i tried using the TOOL ON button but with no luck. I'll go back and check the wires and power connections again.
Peter, I want to say no to most, but, I did do an update for either OpenBuilds, Lightburn or Vectric V Carve last week. Just can't remember which...
No joy. Still no startup on the router. Can get it to start manually by plugging the router in a different power source.
Yes, Peter, it is still set to 1000.000.
Shawn, I still cannot get the router to turn on automatically. I went to the Gcode and typed in M3 S1000 ; Turn Spindle On and M5 ; Turn Spindle...
Thank you! Not sure what happened as the router was working. I'll go through the setup in the morning and get it running again.
Where in the OpenBuilds documentation is the file for the router to start and stop automatically when the Run Job button is clicked on? It was...
Okay. Thanks Peter.
Why is my model centering? I used Vectric Desktop to get my model ready for 3D engraving. In Vectric the model is centered on the material but...
Thanks Shawn. Knew the probe let the machine know where to start on the project but didn't know it also did the zero. Love this forum. Always get...
Do you zero the x,y,z after the probe? I positioned the bit over the probe and zeroed x,y,z. After the probe z is at o.512. I am good to go or do...
Thanks Peter, I will look at that when I get out to the shop.
I am having a problem with my J Tech laser and I do not know if it's an OpenBuilds, J Tech or Lightburn problem. No matter what I increase the...
I had no idea. Thanks for that info. I will dig into this in the morning and go from there. Thanks again. You always answer my questions and quick!!
Thanks, Peter, I didn't go through Cam. I uploaded the g code straight from Lightburn using Control. Should I use Cam to upload from Lightburn?...
How do I tell Openbuild control where my job is? I used Lightburn to created a job, saved the G Code and sent it to Openbuild control. By looking...
Go to this page and just scroll down a little bit and you will see the two settings. it's just under the Laser Mode Overview. You can create...