Separate names with a comma.
Some features disabled for guests. Register Today.
So how do I set the % of power without using the Turn on icon? Peter, I found my answer. I set up the settings I want in LightBurn then save to...
Ok. That seems to work. The only question is in the laser mode when I "turn on" the laser it comes on before I start the job leaving a burn mark....
That was it. Thanks! So if I read that right if I want to use the router I have to edit $32? Also, the only way I can turn the laser off is to...
I have a Inventables X-Carve 1000 with a JTech laser. I imported a file from LightBurn to OpenBuilds Control which is also connected to a X 32...
Thank you Peter. I THOUGHT I had looked at every page. :oops::banghead:
Oh Thank you!! That's all I needed. At 72 my eyes just can't read print 1/32" or less. :):( And thank you for the Grbl settings. I will check that...
Yes, the router switch is turned on. I am trying to turn it on with the tool on/off in Control. Everything works except for the router. The jog...
I have looked at every picture at your link many times. Can you just tell what the icons are? Apparently your eyesight is so much better then this...
I am running an Inventables X-carve 1000. I do have a Jtech diode laser for it also. I just setup the Openbuilds 24 volt power supply, the X-32...
Can someone direct me to a picture or diagram of the 7 icons on the front of the X32. The print on the x32 is so small I can not read them! :( I...
I have a Inventables X-Carve 1000 and the limits switches only have two wires, a red and a black.However, the X-32 has three spots for wires. How...
Thanks, Peter, I am heading there now!
You, Sir, are my best new friend!! That was it. And I thought I had gone through every page in the manual. Now I need to find the pages on...
I am trying to get the 24 volt power supply and the Blackbox 32 setup. The problem is when I jog the x-axis and the Z axis they both move correct....
Thanks again, Peter!! Hope you like to answer questions because I have a feeling until I get used to OpenBuilds I will be asking plenty!!!! :);)o_O
I know you can use different probes with the X 32 Black Box, however, I have no idea how to wire/connect/switch them. I looked through the...
Thanks Peter, I will head there now.
Has anyone swapped Inventables X-Controller with the OpenBuilds X32 and their 24 volt power supply? If so I could use some help please! The wires...
Super! Thanks for the links. I will go through them tonight.:)
Can the X 32 replace the Inventables X-Controller? If so will I still be able to use Easel Pro, LightBurn, Vectric Desk Top and such to send files...