Separate names with a comma.
Some features disabled for guests. Register Today.
Alex, thanks for your reply. All the wires are good. I ran the roughing file right before with no problems. Just seems weird it was working one...
Need some help for my probe. I loaded Roughing file and the probe worked great. However, after that file was finished and the bit went to the home...
Think I it. When I go to grbl settings and scroll down to $6 there no way to put in 1 or 2, the only choice is Enable or Disable. I changed it to...
How do you edit the GBRL settings in OpenBuilds Control? I need to edit $6 or at least see whats it's set at.
Thank you for your reply. I change the $6= in the morning. Hopefully this will finally fix the problem. :thumbsup:
Sorry all, but I am back to my original problem. Right now the red trigger shows in troubleshooting. When I jog the bit over the hole on the plate...
oops sorry
I used my volt meter and checking at the connector attached to the plate I am getting 5.00 volts. i used the black probe to black wire and red...
After changing $6 to enabled and rebooting I went to the Troubleshooting and the probe was not triggered. I will follow the steps you gave me in...
Shawn, good news bad news. Good news is the $6 was disabled and I changed it to Enabled and saved it. I rebooted not only OpenBuilds Control but...
I put the black and blue wires directly to the x-controller and the other end is the connector that came with the probe which I plugged into the...
Giarc, I connected the black wire to ground on the X-controller and the blue wire to Probe. I rebooted and connect OpenBuilds Control and ran the...
Wow, guess I was told wrong. I was told the blue wire was for the LED light. I will change that tomorrow. However, after I unplugged and then...
Thanks for your reply, and, yes the probe shows triggered. The wires look good but I will reinstall them. The X-controller does not accept a 3...
I am using OpenBuilds Control for the sender to my Invetables Xcrave 1000 Xcontroller. I get the following error message. How do I fix this error?
Your right, the xcontroller only has a 2 wire probe hookup. Not having a light come on during the probe cycle is not a problem. I think the xyz...
Does anyone know if the xyz probe will work with the Inventable Xcrave 1000 and the Xcontroller? I am using OpenBuilds Control and made the...