Separate names with a comma.
Some features disabled for guests. Register Today.
I'm measuring with a dial caliper that is accurate to .001" and it moves at least half a centimeter different each time. And when I go back to the...
So exactly how tight should the belts be on this OX? I have a tendency to overtighten everything. My belts are pretty **** tight right now, And I...
I'm about to just give up on this PWM Speed Control issue. On another note, I cannot get my axes to move the correct amount of distance...and if I...
I have this exact speed controller...the listing is for multiple different speed controllers...It's the very last one on the right in the list...
I bought them together as a kit. I tried the potentiometer BEFORE chopping it off...and it worked fine. The speed controller is rated for 5V PWM...
I have checked the voltage at the xpro SPL terminal. When I give an S command followed by a number, the voltage changes accordingly. S0 is off and...
I have the same speed controller that's in the CNC xPRO build section (at the top where it gives instructions on wiring the speed...
My CNC xPRO is loaded with GRBL V0.9i. I just got it about 3 weeks ago. So do I have the motor/xpro/speed controller wired up properly? Motor...
One other thing...when I give a command such as M3 S700, it has no effect at all. I can enter ANY speed and it has no effect. Neither does an M03,...
Hey guys...I have my CNC xPRO V2 up and running. All is working just fine except for the PWM spindle speed control. When I turn everything on, my...
Thommy, I need one of those aluminum plates to mount my 52mm quiet cut spindle to my OX cnc router. Can you help me out? Justin Dewoody...
I got it figured out. Thanks for all the responses :thumbsup: Justin
Can you guys please tell me how to wire up this PWM speed controller to the CNC xPRO so that I can have software control over the RPMs? I have the...
Where does everyone get their router bits? I need a set. I'm thinking I need a 1/4", 1/8", and 1/16" flat end mill, a 1/4", 1/8", and 1/16" ball...
So what are some alternatives? How about the Geck G540? Is it a contoller and drivers all in one? Is it a direct replacement for the xPRO? And can...
And just to confirm...it's NOT possible to run Mach3 with the xPRO...correct?
I have another questions guys...once I have everything wired up and ready to go, how do I install the CNC xPRO (software wise) on my PC? Is there...
I guess I'm still a noob and don't really know what I'm talking about. I got a lot of learning to do...
Really? I thought I could use UGCS, GRBL, Mach3, or ChiliPeppr...
Jonny are you talking to me? Which posts specifically? Thanks.
