Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks Peter! I used those and the built in Fusion libraries to get a rough idea and dialed it back from there until the results came out ok. Cuts...
Hello all, Is there a recommended and max feed rate for the 1515? What spindle speed do you guys typically use on soft woods for Router11?...
Welp, ran into another hiccup today in Fusion and not sure where I'm going wrong. I dunno what to even search for to find out.. Learning all the...
Yessir, that's correct. I need to look back at what offset I used - could've been the bottom height set to -.01 or something along those lines. I...
Definitely need to dial in the depth of cut a bit. Do you guys typically use an offset of X to clear your stock material or make the stock...
I believe I did!! Managed to get four of the clamps cut out; had to go back in and dial back the feed rates a bit, but it all eventually worked...
I believe I got it!! Had the orientations wrong and didn't post the entire setup thread.. Only the pocket operation haha.. If you wouldn't mind...
Thanks so much for the clarity Alex!! My thought yesterday was possibly the OP CAM would be easier to pickup and learn, but ran into the roadblock...
Hey guys, hope everyone is well. I'm struggling here. Feel like there's a big disconnect [in my brain] going from a Fusion 360 CAD file to CAM.. I...
Made my first cut yesterday!! Everything performed great!! Need to run the job from the interface, but after that I'd say she's complete!! Will...
Got it! Installed the current firmware version to the thumb drive, transferred drive to Interface and updated going that route. Once the firmware...
Also, what is the 'dongle' ICSP used for? Didn't really see a place to plug it in
Hey everyone! Workin on getting the interface setup and when I try to update the firmware I get an error [Unable to check for updates] [Server...
It's alive!! Took me two tries, but finally wore the block in enough to shoot back and forth without issue. First time I tried, the gantry would...
Awesome, Alex thank you!! Will let you know how it turns out!
Gotcha, will do. Just need to get X figured out.. Going to try disconnecting the motor and turning the lead by hand to seat the bearing..
Just divide the default 1270mm / 2 to get 635mm?
Thank you sir!!
Welp, just ran into an issue.. Y and Z axis work fine, but the X lead screw is likely bound. When I try to jog, the lead screw doesn't turn, but...
Making progress!! Setting up the Control Software now and curious if I need to make any changes to Y axis max travel length or any other parameter...