Separate names with a comma.
Some features disabled for guests. Register Today.
Yes, I have a microswitch connected to the Arduino and the Error 33 happens on the G3 command soon after the probe and Z axis move and pierce...
Just put it in check mode ($C) and the last gcode file I uploaded runs in check mode without error. Put it back in operational mode ($C again...
I've confirmed that while I'm using Arduino Uno R3 and not BlackBox, I'm rusing grbl 1.1 commands
Update: I went into set up in Fusion and edited the tolerance under Passes to 0.0001 ( it was 0.001) and when I saved the file, fusion gave...
USB device on the Arduino is: ATMEGA 16U2 I'm assuming it's the same chip on the other Arduino that's actually on the machine, but I can't be...
No new stuff to post yet, but I'm about to generate new gcode after replacing the post processor file in Fusion. And I'm using an Arduino Uno...
I did post my files logs, fusion and g code previously. please see post number #61
Finally, was able to get back to troubleshooting this, even though I'm 1600 miles away from my CNC machine, New USB cable, same files as I...
I’ll. Try another USB cable. But I’ve already used two different ones and I moved away from the steppers and plasma cutter I’m also going to...
FWIW, Here's another file that error33 occurs on now. Fusion settings: Clearance height 0.4"(Default) Retract height 0.2" (Default) Top...
Yes, $11 is set to 0.010
OK, now I got a file that works without error33 occurring. All I did was set the lead in distance to something greater than 0, re saved the file....
Darn, that didn't fix it.. I still got the error33 its occurring when the move to start the outer cut finishes the probe. I have a small...
David, If I understand your explanation then maybe I have found the problem with one file that still was giving me an error33. Here's the...
OK so this morning, I reset $11 to 0.010 and created a new design file in Fusion a 4" x 6" rectangle with a series of holes from 3/8" to 1/4"...
The error occurs even when I' just have an Arduino on my desktop and a manually triggered microswitch connected to it. I eliminated the plasma...
It's certainly a mystery to me... Thanks !
Hopefully, this worked. I closed Openbuilds, reopened it, loaded one of the failing files zeroed x,y & z then hit run. Here's the console...
FWIW- I set the Z to 2.95 " ( 75mm) Same result.. Made the change to the .cps file under user adjustments hmm...
Thanks, I'll adjust it to something smaller, however, I have 100mm (3.937") of Z axis travel available, It should only take a few minutes to...