Separate names with a comma.
Some features disabled for guests. Register Today.
I found the issue. The stepper motor has failed.
I’m not sure how to read gcode but the plunging happens in different places. I ran the same program twice. Not sure about EMI. I have the spindle,...
I am trying to cut out some shaker doors out of MDF an the last 2 sheets were ruined cause the rotor started acting like it had a mind of its own....
After I ground the Z axis, I was able to cut the entire sheet with no alarms or disconnect. It’s only one sheet but in my mind that a success.
I do believe I have those limit switches. They are the ones that came with the machine right now I have my vacuum hose and my spindle wiring...
I have grounded the spindle, the entire dust collection hose with a braded no 3 wire to grounding rod. Didn't make any difference. Is there...
Here is a screen shot
5th time in a row the job has stopped in almost the same spot, when I cancelled the job the Home all button does not respond have to turn...
Problem appears to be getting worse. I can only make it with 1/3 through a cut job. I do not get any alarm. It just stops. Right now I have soft...
I am constantly getting the error locked out during alarm state I have taken a screenshot. I’m only getting approximately 10 minutes in an alarm...
Ok have snipping tool set up
Ok the next time it happen I’ll take a picture
Lately, I have been getting error. 9 G code, lockout during alarm or jog state. G1 X276.3590. Any way to figure out why this is happening or...
Lead 1515 6 wheels I’m going to order 15 nice to have spares
Would the extreme solid V wheels be a better choice or is that what is on her now?
OK, thank you I think I will replace the wheels because right now I do have a heavier router and I have had some mishaps where the tool dug too...
There are off set nuts on the right hand side three in total that can be turned to tighten up any slack in the extreme V wheels, but there is no...
1/4 bit 100 IPM 18000 RPM 3 mm deep stock Z axis
Open build 1515
