Separate names with a comma.
Some features disabled for guests. Register Today.
Wow serge 2mm is a lot. Most likely in your bed. Easy way to check is put a straight edge over it. A 3nm will lift 80kg vertically happily on...
Think they are now doing a 1500mm cbeam. Worth looking into tho as only going off a mention on another thread
Not quite sure Im with you on the lever, the thread nut is in the middle so you could say it would pivot around it. But this is the same with ball...
D Doesn't make any difference really, you will have to replace two profiles either way, unless you plan on using cbeam for the X. But the y's...
Twin cbeam is the way to go over 1500mm.
Yes that would work, the nut could even go inside the channel, with just the tip of the bolt in the block. Not as neat but it would work to same...
Yes it would require a milling process as accurate as the original spacers.. You would still require shims so you could leave as much tolerance in...
As a kid I was into inline skating, Bauer bought a pair that similarly had the wheels bolted just one side through a single plate. My mate bought...
Rick is right in where the flex occurs. There actually isn't a lot of difrence in the cbeam design in that it has wheels that are unsupported at...
Should be fairly straightforward with combination of sliding t nuts and corner brackets. Best bet id say is give it a go. Worst case you would...
Of course, yeah that didn't occur to me.
Cool I will check it out. Thanks
Yup and ldpe is more rigid than hdpe lol. Hdpe has more oil it you see
I cant guarantee a build of this type but i can say you would stand a better chance with a 1000x1000mm cbeam build with dual beams in a H/I...
Is that corner to corner? If you have a timber store nearby that cuts mdf, I'd suggest getting a piece cut that's going to be a tight fit in your...
Wish I had some ideas for hdpe, got loads of 15mm thick black offcuts here, enough to make a full sheet. So just a case of cooking in the oven,...
You can increase the cbeam to 1000 pretty simply, had this conversation on another post at the same time. Might be worth chating with this guy...
Yeah, it will melt down into a slab at a lower temperature. That's the impure stuff in it melting which will just fuse all of the parts that don't...
Honestly, you don't need to, that rack needs to be as rigid as possible, any dampening will increase backlash. I know the lines your thinking on,...
With belts I'd say it's the one with the least amount of it.
