Separate names with a comma.
Some features disabled for guests. Register Today.
So I have been chasing this issue with the spindle spinning all the time. Checked all of the VFD setting and advanced setting in OB Controller and...
Peter, u da man. That resolved the vfd/spindle control; running the job now and expect this will likely fix the offset issue as well. Oddly though...
Peter, I was able to upload the correct post.
Thanks Peter, will take a look. May explain the issues. I pulled the post from a source on this form not knowing it was not the correct one. are...
Peter, I will review the docs. For reference, I have attached the gcode.
Thanks Peter, I will reach out to the Huanyang. Complete newbee hobbyist so forgive the questions. But, does the spindle speed programmed in...
PD006 = 2.5 ; default value for Intermediate Frequency (Hz) PD007 = 0.5 ; default value for Minimum Frequency (Hz) PD008 = 220 ; default value for...
PD000 = 0 ; parameters left unlocked, set to 1 to lock PD001 = 1 ; required to use Shapeoko’s PWM signal as the activation trigger (default was...
Anyone, I reviewed the VFD set points and the advanced setting in controls. All seems set to logically stop the spindle from spinning based on...
Great, thanks. So, the picture is the result of a project created and code made on Fusion 360. Not sure what occurred as this was not the intent,...
excellent, I will take a look. Also, should I make another post about the table not making accurate tool paths or post here? I can upload my file...
Peter, on another topic and let me know if I need to start a new post. I noticed recently that after a project, my router remains on via the vfd...
thanks again Peter...
Hi Peter, thank you for the feedback. After thorough investigation I found a bad contact on the drive wire connection. Repaired, what is the best...
Hello, my table is just started having issues with the y axis drives opposing each other. Both drives work, but when adjusting the y axis in...
Thanks for the information and suggestion Peter.
looking at purchasing the 1515 to expand my 1010 cnc routing table. Is this easily accomplished? To be specific, are there any programming...
Peter, you da man. Thanks for your detailed assistance and patience.
