Separate names with a comma.
Some features disabled for guests. Register Today.
Thank you, Peter, This would be the right way to go.
To whom it may concern: I have two Meanwell power supplies, one for the spindle and one for the Openbuilds X32 Blackbox controller. I operate...
Thank you, Misterg, You are a scholar and a gentleman.
Is it possible to change the shortcuts for the jogging etc? I messed up a job hitting the down-arrow on the keyboard... My bad! Thanks again for...
Thank you, Alex, I appreciate the information very much! Regards.
Thank you again. Makes sense.
Thank you again, Misterg, Just a question(s) is it preferred to run in absolute (G90) or incremental (G91) mode? I understand creating arcs or...
Hi Misterg, You were right in your thoughts upon investigations. Thanks again for all the information and insight. Regards.
Thank you, Misterg, I will check but thank you again for your feedback and your insights. It is extremely helpful! Regards.
I had been typing in the command G91 X0 Y0 Z0 before any other commands. That would put it into incremental mode, if I am not mistaken or how...
My bad! I read the documentation and managed to connect through my wifi and then X32 Blackbox is working beautifully through wifi. Thank you...
To whom it may concern: This morning after weeks of operation, I had strange behaviour occur. I would be sending G-code commands in this...
To whom it may concern: Can I run the G-code from the PC via wifi instead of the USB cable? Or is the wifi connection option intended for a...
Thank you, Peter, I got such a fright, I shut it down, I will test it. Thanks again.
To whom it may concern: I had a strange event occur. Please take a look at the image attached. I was making small slow consistent movements in...
Thank you as always, Peter,
Thank you Peter, What added benefit would I get upgrading web builder? Would there be a performance benefit?
Hi Peter, Thank you for the information. How do I access the grblHALS Web Builder builds and how would I flash it to the X32? Thank you.
To whom it may concern: I am running v1.0370 Openbuilds Control software with the OpenBuilds X32 BlackBox controller. Should I be checking for...
Thank you for the help and the great documentation in regards to the X32. The controller and software are more impressive the more I use it.
