Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks I will try that I have the open builds controller
I moved my spindle to create a greater cut distance for a project. I loaded a cutter and lowered the Z axis to zero the tip and found I was a few...
ok cheers
I now have a functioning CNC my problem now is the accuracy when cutting circles. Its a ball screw machine no belts is it to do with...
Thanks that what i thought will try it today
[MEDIA] . I ran the Open World program with no issues and a couple of freebies I down loaded machine ran for over an hour without problems. I ran...
I have tried all those things dialled down acceleration as requested it worked fine first thing I have checked everything if I could upload the...
Sorry for the delay in replying i tried to upload a video but for some reason it won't let me it says its a MP4 issue. I thought all my issues...
i have found the issue with the program causing the problem with Z axis. Wit regards to the potentiometer I connected a multi-meter to the tool...
Just to update it was a problem I created in doing the program that caused th
I will check the belt and reduce the Steps I don't think its chip load as I tried a shallow profile path and it did the same thing. If its not the...
Thanks for your advice I will certainly try that. I have just set the spindle for manual operation as it doesn't work with the blackbox 32...
Yes same pitch ball screws on all three axes. Calibrated all three axes as per openbuilds wizard. setup VFD to the video you linked in your...
The machine I am running is a Strongholdpro 1000mm x 1000mm using the Blackbox 32 controller and a hyuanyang spindle Limit switches for homing are...
I have attached GBRl settings what i don't understand it worked fine on the Open World project test. I have been checking out the spindle as it...
The problem appears in the Z move I am doing a drilling operation The Z axis goes down to the top of the collet not 6mm as programmed and either...
I am running my CNC via a Blackbox X32. Using Carveco to create CNC files can you advise which Post processor i should select when saving the...
I removed both Y motors to check lead screws. I ran them forward and backwards using my battery drill no issues. I relocated the Y mid way on the...
No I can move Y to the front -Y but I can only move +Y to the rear about 10mm then it judders. I can move X+ -X smoothly until I try and home then...
the only settings I changed were the Soft and hard Limits by disabling them. In sequence what I did I moved the machine from it's Home position...
