Separate names with a comma.
Some features disabled for guests. Register Today.
You can do it with a teensy board. You'd be building a keyboard emulator: C code for Teensy: USB Keyboard Super simple.
Actually, I can just see the error message in the serial log. It says "target exceeds max travel". This means that in order to complete the...
Again, we need to see the errors before it. When it happens again, click OK, then copy and paste the serial log here. Also, did you look at...
You just reported it :)
Select flood and it will generate an M8. Make sure you have "has coolant" enabled in the post processor settings. flood = M8 mist = M7 flood and...
Check out the build section here. Converting it to rails will be fairly simple. If you want, you can check out how I did it on my Workbee which...
Use the OpenBuilds Fusion Post: docs:software:fusion360 [OpenBuilds Documentation] Make sure you home your machine before setting work zeros....
If I were to guess, its a wiring issue with one of your limit switches. Go into the troubleshooting tab and see if one of them is triggered when...
Thanks. I have the XYZ Probe Plus so it wont work.
Ahhh yes. That might be it, I'll know for sure when I get out to my machine. On my desktop I only have an arduino with nothing connected so no...
And every time you open a file. At least for me. Is that supposed to be the case?
Is that one normally open? I was looking that them the other day and I'll I could find is NC.
There will be on first connect. If you've hit F5 (refresh) at any time, there wont be.
I had that happen on my test arduino. I shorted one of the inputs. After that I would get random alarm codes that never made sense. I swapped...
What machine? What controller? Post your grbl settings so we can have a look. In the meantime: Did you see the OPs resolution? "I found that...
If your machine wasnt homed before setting XYZ zero, or homing failed, then its going to be off. Try this test: 1 - Home 2 - Probe your work (so...
He stated over on the FB page that it was caused by Windows display scaling. Once he set it back to 100% the issue was gone.
Here you go: Xtension Connector Sets
Yep, that's a bunch of tiny moves to make an arc. Since you're using Openbuilds CAM, you'll probably have to wait for Peter to get an answer....
Ok. Its hard to tell in the video but it appears that its a bunch of arc moves. And it certainly sounds like it too. What program are you using...
