Separate names with a comma.
Some features disabled for guests. Register Today.
OK, so I am just at the point of installing the X/Z gantry on to my C Beam Machine and I am having problems with the top corner brackets. As you...
Did you ever wish you could roll back the clock and 'unpost' something? Looking at the question now it does look quite idiotic. However, in my...
Thanks guys. The PTFE tape seems to do the trick just fine. I'm a few days away from completion (honey do's getting in the way) and my Dewalt...
I'll give it a try. I noticed though that it didn't seem too bad going through the lead screw block. Is that because the blocks now have the...
I'm wondering if I should try to source out some bearings with tighter tolerance before continuing with the build?? PTFE tape should work but...
Hi all. Finally made it home and am starting my C Beam Machine build. I am just getting to the Z axis lead screw install and am finding that the...
Keep in mind that I am a complete noob and haven't even built my C Beam machine yet. I do believe that there are Bluetooth controllers out there...
I think you are in the wrong thread here Vester. You've gone one level too deep in the general talk forum. Nobody will see this unless you start...
I actually just looked for it and it isn't up yet. As soon as I find it I'll post the link here... P
Same here. Everything loads up just fine on the work network and at a hotel network...
OK everyone. I got in on the webinar but had to log out at just under the two hour mark. I have to say that it was VERY well done for a noob...
Starts at Noon CDT
Just spent the morning drawing up a case bottom for my Arduino Uno/CNC Shield in Sketchucam. Not sure how it happened but it ended up upside...
I'm going to log in from work. Shhhhh.... don't tell anyone... :-)
OK. Set all of my stepper drivers to 1 volt and tried everything again. Ran a sample G code (smiley face) and it ran straight through it. All...
No apologies necessary. I am totally new to this so every little bit helps! :)
I was eventually going to build an enclosure for both the Uno and CNC Shield with a good size fan on it. I just thought it would last over 20...
Hey guys. I finally got all my kit together and wired it up. I have the CNC Shield V3 and Arduino Uno, a set of 3 NEMA 23's and 24V power supply....
Thanks guys. I have signed up for the Fusion webinar and have also since downloaded Sketchup and Sketchucam. I will definitely go through all of...
Pololu - Video: Setting the Current Limit on Pololu Stepper Motor Driver Carriers Not sure if this has been posted anywhere before but I thought...