Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks for that info. Certainly alot of places for inaccuracy to build up. I did find that after a little use the Z Axis had some play in the...
Ah ok I see your point - and yes I did fall for that one early on as I do have a 6mm bit and a 1/4" bit and more confusingly the 6mm bit has a...
Flass22 - What do you mean by tool offset? I did set teh x and y zero point allowing for half tool diameter.. The over sizing seems consistent...
Not sure about tool offset?? I did 2d adaptive to rough out the hole leaving .3mm and then 2d contour to finish to dize. And on the outer of the...
Hi all, recently finished and calibrated my CBeam XL and have made a few test pieces and parts in MDF. One test I did was to cut a 40mm square...
Hhhm I like that idea and admit I also need to “plane” my spoil board. A job for tonight
I think what you have done is either set the origin for the CAM on the STock corner and maybe still have the STock size (in the SETUP) with 1mm...
I used the "D3 Z probe" and Gnd pins 4th and 5th from the top on the right side in this image.. I have a V2 board but those pins appear to be the...
Ok found a fix of sorts... It works fine with Universal Gcode Sender v2.0.. so will use that. Does grblv1.1 need UGS v2? Anyway - working find...
On my build - Its a Cbeam XL but the Z axis is similar - I found the X-axis subassembly ie the frame with wheels in it caused the font plate to...
Hi, I have Universal Gcode sender v1.09 running ok to an Xpro v2 card into a CBeam XL from Ooznest. Also just got the limit switches setup and...