Separate names with a comma.
Some features disabled for guests. Register Today.
I having issues with my phone but I was able capture this from the homing sequence
Gantry Machine Coordinates checked As viewed from the front +X moves to the right -X moves to the left Home position. +Y moves to the front -Y...
I have been away for a couple of weeks. Back on it today. The machine has been working fine Homing ok until today when I taught the XY0 work...
I must apologies I found the problem The $5 was set to =7 and not =0 All working i will check if the spoil-board is correct later
I have put into continuous jog and the software telling me its gone into soft limit. Disable soft limit and its ok. The carriage is at least...
Y didn't stop it reversed direction at a given point in its travel axis was nowhere the Y switch it was about 150mm away from it. It's happens at...
I have checked the axis and x,y and z operate as described in the video. X moving to the right is positive movement Y moving to the rear is a...
I will have a look Tomorrow. I have a large spreadsheet to finish for our Field Archery Comp on Sunday at the moment
When I run the framing it runs in the opposite Direction The simulation i would expect to go positive in X it runs in a negative direction and...
the machine just sits there not moving when I run the same program!
gcode attached
Using the surface wizard to flatten my spoil board set parameters run simulation nothing moves! I have attached a screenshot and a screen grab of...
I am sorry i am not up to speed with respect to computers I have attached the properties of the interface and properties of my Wifi Jurrasic...
No it wouldn't connect
I have just tried to connect my Open Builds Interface using your instructions section 3 I have run the procedure with no success i have logged...
I have solved the issue I slowed the Axis down when I was having trouble with the limit switches. this was what caused the problem. Returning the...
Checked that everything says green for go. I can jog the Y but it doesn't move when i Home
Hi, Finally sorted homing cycle in Z and X the problem was the limit switch wouldn't trigger. Both switches were poorly positioned so as not to...
I will try that a bit later jus awaiting a delivery