Separate names with a comma.
Some features disabled for guests. Register Today.
I ended up getting mine close enough for my needs. But out of curiosity which mount did you upgrade to?
Hey guys, I'm currently designing a dust shoe really similar to the one available in the openbuilds store. However, I'm using a 4" dust hose. I'm...
Here's my current settings in the wizard. Everything else is stock and I haven't adjusted with the machine. Also to point out, I can zero my Z...
Okay, I've gotten it to where I would consider it "close enough". However when I run the surface job using the wizard in openbuilds control. My...
The gap is different along various points. Sometimes on the upper beam, sometimes the lower. However again, both beams are fully seated and...
I made sure the uprights were square to the assembly when initially building the machine. I'm not sure of how to check for square now with Yeah...
@Rhett E I saw on another thread you mentioned adding a couple bolts to the bottom of your z axis to do some adjustments. Do you have any photos...
@Apeli did you ever figure out a solution for this? I have the lead machine but am having trouble tramming my router front to back. Would like to...
I finally got my x axis trammed but even with everything tightened down all the way it seems pretty easy to knock it out of alignment. I figure as...
After doing some more testing, (my dials should be here tomorrow) I've found my router leans ever so slightly forward. I've noticed that it will...
I ran a quick test and took a few passes at the front of my spoil board. I took 1mm off because I'm still waiting on a dial to gauge my tramming....
I'm about ready to surface my spoilboard for the first time. After watching a few videos I noticed the cut area for the machine doesn't allow the...
My stock origin point was just set to default in the center of the model. I updated this in fusion to be the bottom left hand corner and that...
Hey Everyone, I finally got my lead 1515 machine up and running and wanted to run a quick test to check the tramming of my router. I mocked up a...
Great news! Thank you!
Mac. I tried plugging my phone into my laptop with the same cable and it only charged and wouldn't let me access files. I'm going to try getting a...
After reading through most of these replies I'm still struggling with flashing my interface. I have been able to connect it with a different USB C...
I was going to have only the front half of the table open up. Just to make it a little easier for getting material in and out.
My kit should be here tomorrow. Super excited to start this build! Does anyone know the total height of the machine? I'm wanting to build a table...