Separate names with a comma.
Some features disabled for guests. Register Today.
UPDATE: better late than never I say: I finally made all the recommended changes to my CNC build with regard to eliminating EMI, new dedicated...
Gary: Sorry about the delay in responding regarding the 65 minutes it takes to run the spoilboard surfacing, maybe you can give me a hint as to...
I've been busy with house chores and Friday morning I will inspect my electrical pony panel in my workshop (power from house main panel to...
Gary, Mark and Rob: Thank you all for your input, In the next few days I hope to find the time to make the changes. From all your input I'm now...
first off I must say that I/m a hobbyist and still quite a noob when it comes down to the CNC learning curve, I have a busy retired lifestyle with...
I should have paid more attention to that EMI factor. I will now invest in some ferrite cores Thank you
Peter I did take notice of your comment regarding the pass through with the interface, just forgot to take notice and give thanks. I disconnected...
I have made the changes to the USB suspend. in my computer, both are now disabled. thanks much.
Gary" I appreciate your reply and have now changed my sleep settings. but since I'm not too computer savy I will try to find the USB settings area
machine is Openbuilds lead 1010 used the Openbuilds wizard setup for spoilboard surfacing previously and in this procedure I had run a couple of...
ok, understood, all good now except I could not find anything in GRBL relating to why I cannot change $13=1 for inches. In GRBL i change it to...
Then click save ? There is no Save Button . Please help me choose Tom
$22 was also enabled Tom
Peter" i went through the process again, went to GRBL settings, reentered all the GRBL choices for my lead 1010 machine. Whatever happened to the...
I'm starting to pull out my hair. I have been going over all the GRBL settings trying to set the GRBL variables to fine tune the machine to my...
Im thinking of adding a laser diode for engraving and thin woodcutting in the 6 or 7 watt range to my lead 1010 setup. There is a price difference...
OK this is weird, I uploaded the Langmuir Crossfire Generation 2 and Crossfire Pro plasma CNC break in program and when it opened up there was the...
problem fixed !!! Peter was correct, I must have created a short, and my lesson learnt " shut off power when adjusting limit switch positions"....
Yes i think power was on and usb was defenitely connected
I unplugged all wiring to the blackbox still cannot connect, tried everything. looks like the blackbox is dead
