Separate names with a comma.
Some features disabled for guests. Register Today.
do you mean it could have shorted out the blackbox ? I did check the wiring at the limit switch but could not see a problem
I was setting up a new location for my upper Z hard limit and the hard limit must have triggered, then I was disconnected from the blackbox, now...
Companies that provide this kind of customer service will survive and flourish. My money is on openbuilds for the future
Alex: Another good point, I will pick up some bare copper wire. thx. Robert: Good point, I had decided to order the Vcarve Pro software but...
Alex: Thank you for your reply which led me to do some testing as to where the interference was discovered. It is now working well. Here are some...
I had the spoilboard surfacing started ok but later I started having trouble with the machine shutting down . The shut down message was as...
I have been reading a lot on how to operate my Openbuilds lead 1010 machine and since I'm just starting out I have a number of concerns. 1. Is...
Peter: You are correct. My thread should have been referring to the back of the power supply and not the back of the blackbox. sorry about...
That should have been M4 not M$
turns out the M3 is too small, the M5 too large, however the M$ thread fits. I'm off to Lowes. Thanks Tom
I am relocating my blackbox under my Lead machine and will be making a bracket which will be held onto the rear of the blackbox. There are four...
giarc: Thank you for your reply. I checked the available post processors listing in the inspire software but there in nothing listed for openbuilds.
Never dont this before and I am at a loss how to transfer my CRV3D file which is a drawing with two toolpaths into the Openbuilds CAM generator...
Got it working fine now. basically the problem was my fault where I neglected to set up my machine properly after I had a replacement blackbox ,...
it was disabled, so after enabling it started to work. Only problem now is when I try the home all, the Z goes up and stops at my upper travel...
This has to be something simple but my HOME ALL is greyed out and I cannot home the lead 1010
Hi Alex I found it and you are correct, it is a stl file. Since I do not have a 3D printer I have sent the file to my buddy who will print the...
I can no longer find on the openbuilds site where the 3D printable DXF file is located. Is there a seperate area for 3D printable projects ?
When will the interface be available ?
After bringing this to the attention of the parts dept. they increased the price of the kit by $10. thanks
