Separate names with a comma.
Some features disabled for guests. Register Today.
I started to carve my first actual job on my Killerbee with Openbuilds control, using the Interface. I started the job and forgot to put the...
Just starting out and tried out the Openbuilds XYZ probe, I followed the instructions, but when I came to use it. I positioned it onto the corner...
Thanks...pretty obvious if you think about it! Thanks
I haven't used my probe yet still sorting a few problems. I've watched videos of everybody using then on the corner of their workpiece. Is...
Ok thanks ill give it another go... Just been thinking...... Also, when I jogged the machine to where i wanted it to start from and zeroed all...
It may be me... But I started surfacing my spoilboard with the built-in wizard in control and decided it was too deep a cut. So, I stopped the...
oh thanks for clearing that up..I will try an air cut tonight unplugging the Interface from the Blackbox. Will remove the cable too instead of...
When the USB disappeared, i looked on Control and it said I had 391 jobs in the queue? Id only added the 1 surfacing job
Hi its a Chinese 800 watt, water cooled spindle. All VFD cables are screened and run up the extractor hose to the VFD, none running in the drag...
Hi Alex, it suddenly appeared again after spending all night on it... So I thought id give it another go and set up the surfacing wizard again,...
Turned on my Blackbox today and went through the Wizard to surface my spoilboard. I set all the paremeters and jogged the spindle to the correct...
I received a Openbuilds blackbox and Interface and received little USB drive. Whats the purpose of it?
Not sure what happened but just setting my CNC up with a blackbox and Interface. I've played around with the Interface while building the machine...
Hi thanks finally got it sorted. I was getting a voltage from the blackbox to my VFD. The problem was the settings on the VFD. I had turned on...
What voltage should it send to my VFD
Thanks..oh it didn't turn it on?
Im still building the machine, nearly finished! so have been sorting out the VFD and spindle side. I did have it not connected to the Blackbox and...
Hi will be using Vectric
How / where do I send a M3 S1000 too ?
Hi I have a Invertek VFD and want to control the RPM of the water cooled spindle with the Blackbox. I have connected a cable to the ground and...
