Separate names with a comma.
Some features disabled for guests. Register Today.
There is no fault light when it stalls. It stalls and moves on. What can I do to check the Blackbox?
New cable did not make a difference. Half way through the file the axis stalled. I ran it again with the current pot turn all the way up but it...
The normal gcode speeds I run are 100-150ipm in hardwood and for pine up to 200ipm without any issues. This recent issue came out of the blue...
I understand your point about the speed and was only trying to point out what I have tried during the troubleshooting process. I can tell you at...
Ok this is getting frustrating. I set the max rate down to 5000 and the acceleration to 150 on both axis and run multiple jobs without any issues....
I played around with it today and I have concluded that the steppers were advancing too fast. I could consistently cause the problem while...
Here is a short video of what I am hearing.
Checked all the connections and found everything was secure. I set up a surfacing path so I could watch it run for a while. About 3/4 of the way...
Just ran a couple of gcode files and all went well until the final move to the zero position. It stalled in X. DRO reads 0,0 but it’s about 3” shy...
I am using the black box. It seems to stall at the beginning of the move. Was running a lot of air runs so no load and still saw the problem. The...
Guys, I have been running the Workbee 1000 for a few months now and not have too many issues. Today, I started running a job and immediately...
Thanks Mark. I’ve made the changes requested and will monitor the changes. I will take a screenshot of the week next time
Here is the macro. G38.2 Z-25 F100 G91 G0 Z3 G91 G0 X-50 G91 G0 Z-8.2 G38.2 X30 F100 G91 G0 X-3 G91 G0 Z8.2 G91 G0 Y-50 G91 G0 X50 G91 G0 Z-8.2...
I have made some simple macros for use with my touch plate to find the zero positions of XYZ. There are times that they work fine and others when...
Sound advice. How far from power cables should they be? Is outside the cable carrier far enough?
Job completed in a little over 4 hours and no issues. It must have been EMI. I did not make any changes to the wiring location at this time. I...
I have the newer ones. I am rerunning the job this morning and it’s been going for about 45 minutes without an issue so far.
I do remember that the system did give me an error message stating limits had been exceeded. I am running the Open builds limit switches that...
Workbee 1010 with Blackbox and using Open build software.
Started running a large 3D carving the other day and when about 3/4 of the way through the system locked up stating limits had been exceeded. I...
