Separate names with a comma.
Some features disabled for guests. Register Today.
Ok, thanks
Is there a way to turn off the spash screen advertisement?
I understand that the xPro uses a fork from grbl, but it seems to me that the issue is related to how OBC controls the usb driver rather. Once the...
Ok, thanks Peter
I'm having an issue with version 1.0.329, although I'm not sure if this is version related. When I switch on the controller, an xPro V5, and then...
Thanks both. Peter, the reasoning for NC being a good practice that Ive come across, that actually makes a lot of sense to me is that whenever...
Hi Peter, I have 2 questions regarding NO - NC just for my education. I'd like to better understand the reasoning. To not open new threads, I'll...
Apparently the issue is solved. Not completely sure what single thing did the trick, or if both things contributed. I bypassed the GX connector on...
No intention to change it, even less now that I learned that the board has that kind of jumpers. I expected typical jumpers, those that can be...
Thanks Gary, I'll look into it
Peter, I appreciate you replying swiftly to my questions, I really do. Regarding the "influx" of questions, or me spamming the forum, as you...
Hi, My unit did not come with jumpers for adjusting micro-stepping, as shown in the official documentation. Where or how can one config...
Thanks Peter, I'll look into your indications. Dully noted not to spin the motors when connected to the controller!
On further review, it turns out that the y motor is erratically changing spinning direction. Check the video [MEDIA]
Hi, I have a SPAM equipped with a BlackBox controller, which replaced a faulty xPro v5. I'm having issues with the movement of the gantry (Y and...
I successfully wired the NC end-runs following your indication, thanks.
Thanks Peter. Dully noted that the 3rd terminal (NO in this case) does not equal V+. As per your instructions I'll keep the jumper on 5 volts....
Thanks again Peter. I have just received my BlackBox I'm trying to identify the terminals on the micro switches as per your instructions though....
Thanks Peter. Just to be clear, when you say "loop", you mean to bridge them? Regarding your question. I mean setting the corresponding jumper to...
Thanks Peter. I already have switches (regular ones), which at least for the purpose of homing, have worked fine so far, without any false...
