Separate names with a comma.
Some features disabled for guests. Register Today.
See wasm't even my guess (: That one means you skipped the Interface Documentation (: - Section 3.2 PREPARE THE USB FLASH DRIVE...
Sounds like bad wiring: docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation] - Our FAQ would still apply to other controllers,...
$6=1 in Grbl Settings (our default profiles)? Tested in Troubleshooting tab? Not a known error that one.. Exact screenshot of error (not just...
Just do it (: repeatability, jigging, job recovery, easy to understand offsets. Worth the couple bucks every time
No, $23 is "where is the limit switch" - no relevance to where motor is. $3 corrects motors so machine follows cartesian. $23 is assuming machine...
Recheck :) No, use one of the profiles in the LIST :) - at least as a starting point - you can use the other vendors settings manually but don't...
Takes two things to move motors: 1) Did you remember to load a machine profile (CONTROL > Grbl Settings > Select a machine from the list 2)...
AC Earth to DC GND short circuit somewhere in your setup. Unplug things one at a time to find the source of the short then fix it.
Just read the three lines linked (and highlighted). That was just a link to instructions/info...gotta read it that's all. [ATTACH]
Checkout docs:software:overview [OpenBuilds Documentation] Rarely used could sometimes be : "didn't quite get the hang off it, crashed it a lot,...
Edit the macros on the USB drive, standard macros assumes our probe docs:xyzprobe:start [OpenBuilds Documentation] Not using our probe does come...
OpenBuilds-CONTROL/app/lib/threejs/OrbitControls.js at c3233c29aca89e89b48b92067dff5f67f33a1bdd ยท OpenBuilds/OpenBuilds-CONTROL
Yes. The next section (toolheads) are more important CONTROL doesn't have anything like that. Just the $30 Grbl Setting. My screenshot is from...
You definately forgot to setup the VFDs Min Freq (120hz) or min RPM (7200)! Dropping that low will burn spindle windings, turn on the VFDs...
CONTROL latest version will connect to grbl 1.1f or 1.1h GitHub - gnea/grbl: An open source, embedded, high performance g-code-parser and CNC...
Yes, to the ATMega RX/TX pins correct, USB chip in parallel will usually be fine See docs:interface:connect-generic [OpenBuilds Documentation]
OpenBuilds did not supply the xPro V5s, so we cannot assist with it. We never did sell the V5s. Neither did we supply the VFD We do support the...
In essence almost all VFDs accept some kind of dry contact RUN/STOP signal (Relay on BlackBox or panel switch, or alternatively not even wired up:...
Might be a good idea to consider a BlackBox? docs:blackbox-x32:connect-vfd [OpenBuilds Documentation]
Very good, definately better than inductives (they are temp sensitive - temperature rise affects the B(H) curve of the magnetic core, etc - not...
