Separate names with a comma.
Some features disabled for guests. Register Today.
I used just the caps connected to the GND, as suggested by Rob in another thread, and it works just fine. No resistors.
What Jeff said is right. You can buy that enclosure, or any other that you like, and just drill a few holes into it. 1/4" holes or even 3/16 will...
Jose, did you make a test file cut on your machine? You know, something with two different size circles and squares, all on the same center, with...
As Rob said, the BlackBox has the Uno circuitry in it. Like you, I had some drivers (DM542) and all I needed was an Uno. I ended up using an...
I don't think those driver can handle 20A at 60VDC. That's 1200W! I think they are rated at 4.2A, if memory serves me, and even then a good...
I have the 16mm ball screws and they whip if I go fast. They are 1500mm and 1400mm. I bought some thrust bearings and I'm looking for ideas on...
I see you have thrust bearing on one side. Do you also have them on the motor side? If yes, did you make the mount yourself or is it a bought one?
I may not had made it clear that I mean the g-code command 'F' and not the jogging speed. While cutting, I may want to increase/decrease the...
After using the software a little I have two things I would like to add/change. 1. Can we have a field with the cutting speed, be it in in/min or...
I promise, I never gave it a bad review, not even among my most trusted confidants! :D
Yeah, it is the jog speed that makes the difference. After posting the previous post I was thinking about it. In Mach3 I used a shuttle and I...
I would guess that one, or more, of your pulleys is loos. Check if all the set screws are tight.
Yes, that's what I meant. Without it, when you press the jog button, the axis move at a rapid pace. Once you let go of the jog button the axis may...
I tried it and I'll call it 50% perfect. :) I miss the option to hold the jog button down and have jog continuously at the rate I had selected...
Thanks, sharmstr. I'll have to read up on how to implement macros and will then try it out.
Was that already implemented or is it still in a 'Not at this time' stage?
Thanks, Peter. I ended up doing what Rob suggested and it worked a treat. Now everything works just the way it should. I may try, at a later day,...
I was going to use a Teensy 4.1 once I got my problems solved but it says on tindle that the board is not available.
Thanks, Rob, I'll try that now. I'll have to find which pin is the logic GND on the Arduino but I guess that should be not much of a problem
I have all the electronics installed in an old computer housing. The wire for the limit switches are connected to the Arduino and to plugs in the...
