Separate names with a comma.
Some features disabled for guests. Register Today.
Now that you have removed the G53 move your first move G0 Z-10 is in the WORKPLACE coordinates system and should go to 10 mm BELOW where you set...
If it really is moving half the distance you told it to there may be other issues, but the start point is to calibrate your steps/mm. The link...
192.168.n.n is a PRIVATE IP address - its a device on your home network, not a website on the internet. Alex. [ATTACH]
Are you sure that the Y switch isn't showing triggered at the start of the homing cycle? Alex.
It is M5/M3 commands, but you don't need to turn off the router before raising Z. My router doesn't turn off when moving Z to the retract height...
Please post a g-code file so that we can have a look at it. It sounds as though you have spindle speed commands where don't need them. What post...
I'm assuming you have a blackbox controller? Did you load a machine profile? Are you using Openbuilds Control? What is your $21 setting? Alex.
If you have enabled hard limits that is correct - grbl will stop the machine if it recieves an input saying that an endstop has been triggered....
Contact the parts store by raising a new ticket at the link below. Contact Us It's a good idea to raise the issue here first in case we can...
I'm assuming you have a blackbox controller? The back, right, up corner is ALWAYS the maximum dimension for each axis in the MACHINE co-ordinate...
You can use the switches to set a machine home position. Where have you located the switches? Your machine will set the position it is in on power...
@Brian Slee, it's probably too late to say this, but when I make a mistake measuring material thickness I reset my WCS Z a bit lower and run the...
Yes, if you really must :) - just wire them in series. Any break in the circuit will trigger an input configured for a NC switch. Alex.
You also need to be sure that your bench is perfectly flat Alex.
Regarding movement in the Z axis - if you have been pushing the machine hard you may have accelerated the wear on the V-wheels. Check your...
Well spotted Shawn. Alex.
You are pushing your machine a bit hard. For hobby level machines I recommend starting with a depth of cut (depth per pass) 1/2 the diameter of...
@Dr.Deo, you might find this link interesting;- Upgraded 3018 Pro using MGN15H Linear Rails and a 500w Spindle @dJOS_500 can you see any reason...
Is the model of the MKS DLC32 that you have meant to be controlled from a PC, or is it intended to be a stand alone controller - I've seen...
In the simulation? I don't have Openbuilds Control on this PC so I can't run the simulation at the moment. Alex.
