Separate names with a comma.
Some features disabled for guests. Register Today.
I havent checked if OB is carrying the spacer yet, but I picked one up from kent cnc directly. Comes in handy often.
Control has a calibration wizard which will allow you to specify the distance.
It depends. If your stock is oversized and are going to mill that sides away anyway, you can just kiss the edge with a turning bit. Then you...
Unfortunately, from the documentation "NOTE: Must be NPN type sensors. PNP is not supported." which can be found here:...
If you head over to the Vectric forum you'll see a ton of posts about this. None of the Vectric products cut pockets efficiently. There are a...
Assuming its a profile cut, enable ramping: Profile Toolpath - VCarve Pro V9.0 User Manual
The BlackBox is a controller so you wouldnt use the nextwave one. What we need to know are the motor and power supply specs so we can see if they...
Pick a similar machine like the lead 1010 and adjust the settings from there.
The easy way is to set up your machine (blackbox) using a computer and OB Control. Control has machine profiles as a starting point, then you can...
Yes, but set x and y zero after homing.
Change your skim depth to .5mm to start. For the width and length, set xy zero then jog your machine around to get accurate values.
Go through the prep usb drive procedures. The probe routines are will be on the usb drive: docs:interface:prepare-usb-drive [OpenBuilds...
Wait for idle, then read it. Pseudo code setTimeout(function() { var waitingToReadValue = setInterval(function(){ if...
Sounds like a wiring issue. Troubleshooting steps here: docs:blackbox:faq-identify-motor-coils [OpenBuilds Documentation]
There's nothing in your obc files. And I'm not quite sure what you want exactly, but you might be able to go into settings and change the start...
Hey Alex, it doesnt. All move are in the current WCS.
grbl doesnt support G64 (see list half way down): Grbl v1.1 Commands · gnea/grbl Wiki Use a grbl compatible post processor.
Ha. I forgot I did that as well. I remember seeing it somewhere. LOL
Well, that's the general stuff, but there's a lot more that goes into it. Wiring, motor couplers, nuts blocks, etc. The Openbuilds machines have...
