Separate names with a comma.
Some features disabled for guests. Register Today.
When I click start and the spindle starts and the z axis goes up, the motor remains as if it was not blocked for a second and I had a situation...
Emisja filtra
I bought such an emi filter, maybe it will help connect it to the vfd
so you propose separate grounding for vfd and separate power supply?
jest w tym samym pasku vfd a u mnie nie ma uziemienia ale mam osobny metrowy przewód wbity w ziemię do cnc i wszystko jest podłączone
Can I use a filter like this? https://www.amazon.pl/jednobiegunowy-dwubiegunowy-jednofazowy-podl%C4%85czenie-sieciowego/dp/B08BC68R63
whether to disconnect one thing the wire from pin 4 from the ground or the grounding of the frame to avoid the loop ??
I have everything grounded I measured with a meter that pin 4, i.e. the mass goes to the spindle housing and the spindle housing is in the holder...
I did a half hour project, everything came out great, no bugs but when I move the axes with the interface with the spindle turned on, there are...
thank you and how long can the cable from the VFD to the blackbox be? so as to muddy the inverter as far as possible?
Hello, I have a problem with EMI interference Shielded wires, all grounded, a filter installed and as you can see, it does what it wants or goes...
ok, so to clear things up when i use milling machine i enter $32=0 and when i use laser i enter $32=1 I remove the jumper and it stays like this...
and for what purpose do you need to change $32 from 0/1 because I don't quite understand if $32=1 the spindle will not run I have a makite milling...
so you have to change it every time? depending on what is used? and pull out the jumper forever yeah?
skoczek
and after removing the jumper and setting $32=1 can I use the spindle normally?
witam, jak podłączyć ten laser do blackboxa 12v? GND i PWM są znane, ale gdzie jest 12v
