Separate names with a comma.
Some features disabled for guests. Register Today.
Some sound advice there serge, glad I'm not the only one who has had issues with the grub screws. What slightly baffles me is why you run your...
Okay that sounds correct. For mach 3 need a mach 3 compatible board. these things are only one or the other afraid to say. Worth searching this...
Do you have a ground between the board and psu? Or Board and mains earth? If so remove it so you only have + and - common from psu and input from...
No, sorry to worry you bud, it makes no real difference only to rounded setup figures. My bad, remember having a similar issue a while back and...
And just occurred to me, isn't 1/8th micro stepping imperial? You should be using metric with a metric belt and settings. Ie 1/5 - 1/10 etc
Theres a step calculator here that may help: http://homepage.ntlworld.com/r.j.noble/ShapeOko/grblcalc/ Failing any of this could be your...
7500 is pretty fast, and 100 acceleration id say was pretty slow, Though shouldn't make a huge difference to the noise unless too fast. How warm...
wow thats loud.. or is that a really sensitive mic? The max rates and acceleration seem low.. im using 6000mm/min max rate and 1000mm/sec...
Sounds like motor tuning and acceleration problem.
No..Not so much the case. When i say i lost steps with mine it was only on the nema 23's the z ran perfectly with its nema 17. I've since given...
Okay for nema 17 and possibly 1.5nm 23's only
I'm afraid not, but as an example a step jog of 0.1000 mm would take 3 tics taking around 3 seconds. I have now changed to these:...
Don't you get the annoying slow tick when step jogging? They Both use pull up resistors to get the max current out of them, for very short...
