Separate names with a comma.
Some features disabled for guests. Register Today.
No the xpro won't work with Mach 3, in fact it's debatable whether the xpro works for cnc at all.
Something else i have just become aware of that was previously unknown to me is that unless you know your bit is completely center balanced with...
I'm no expert but think you will find its all down to chip size, I have some wood specific compression spirals that need to be run at 8-9000 rpm @...
Probably worth going for a new board, Well depending on what you plan on cutting in the future, really for wood you need a setup that can go down...
Really if you want something reliable, and smoother running go for a Mach 3 board. I recommend a uc100 or uc300 motion controller, octocoupled...
Page 84
I think you should read the previous posts before considering the xpro
facing the bed: small amount of chatter, seemed to reduce at higher rpm. most likely down to the dull cutter im using. Running a pretty aggressive...
. Could it be the Usb driver?
Cant promise i've been of a great deal of help, fingers crossed for you. I am guilty of liking a good rant about these manufacturers that hide...
Have you had it running ok and this issue is new? I recall a thread where a guy had similar issue and he swapped out his psu and that fixed it. as...
Really that's not far from the peak current. I would expect to see issues if it were 1 amp or more. But as a rule matching amps is best. Are you...
I only recall it being mentioned as like you say an acceptable controller. I'm not sure that it became a discussion. This compatability statement...
I hope you were not both advised to use xpros on here as sadly It has been posted. They are yet another company that is marketing their 3d...
[MEDIA] First test :) and runs beautifully. Needs some motor tuning and probably should bolt the ballscrew mounts in, but should be making chips...
Low current can be caused by voltage drop, check your psu voltage and driver output voltage also Good luck
that sounds like low current to me. The xpro v2 is rated 2.5a peak, what are your motors rated at?
Thanks! They are detachable for this exact purpose, only issue is there is no features around the side of the screen so makes mounting difficult....
control box v1, awaiting a custom passive motherboard with fault detection and status display screen. [IMG] [IMG] [IMG]
Think it might be a good idea to cut the rack back so theres no way the 2 45nm motors dont try to fly of the end of the rail or round the pinions....
