Separate names with a comma.
Some features disabled for guests. Register Today.
What controller are you using? If it's a grbl controller the easiest way is to use Openbuilds Control - go to the grbl settings tab and invert the...
My answer was because you said you'd fixed it and then it failed again when you shut the box. Another thing to check is if you have a break in the...
Almost certainly a connection on one wire being pulled out as you close the box. There isn't much (anything?) else that would cause those symptoms...
@Daniel Craig the last post on this thread was in 2019, and the original build goes back to 2017 - you might need to find your own sources, but do...
Here - give us as much information about your machine and it's control electronics as you can and tell us what problems you are having. Alex.
I had no trouble finding them. [ATTACH] Alex.
Did you convert the lines in your design to polylines and export it as an R14 version of dxf? Alex.
An even better approach is to probe X and Y using an accurately turned rod (gauge pin) and then change to the bit to probe Z. Only one macro...
Use DRY ptfe or silicone spray (NO oil or grease - that traps dust) on your leadscrews. They do need lubrication, about once per week if in...
Way too loose - start by checking the adjustment of your eccentrics - you should just be able to turn a wheel with your finger. Also check that...
Yes they do loosen up. Hold the leadscrew in a portable dril, lubricate the leadscrew with DRY ptfe or silicone spray and run the leadscrew back...
You are in relative (G91) mode - moves are the specified distance from where you are at the beginning of the line. If you want to go back to where...
Moving this thread from 3d Printers to CNC Mills/Routers Alex.
It says you are sending a jog command before the previous command was finished. Alex.
It could be that something else is trying to use the same port, or you haven't disabled USB selective suspend - advanced section of Windows power...
Found the one I use on Thingiverse - there are several designs there, the one in the link below might be suitable. I've never seen a commercial...
I use a collet mounted fan creating a down-draft that helps a bit with clearing chips. You are correct (looking at your pic you are getting a bit...
What controller are you using? - blackbox (4X or X32) and Openbuilds Control software? If so have you loaded a machine profile (that would set a...
I have the icon on my desktop, double click, pause, double click again. Alex.
Congratulations! It looks as though you could increase your feedrate quite a bit (maybe 8x?). What aluminium alloy are you using? Alex.
