Separate names with a comma.
Some features disabled for guests. Register Today.
Not the feedrate - you need to calibrate your steps/mm (the $100, 101 & 102 settings). Our leadscrews are formed by rolling, not grinding, so they...
I wouldn't recommend homing between tool changes - if your homing switches/sensors aren't super accurate you could end up with a (very small)...
Just be aware that; A) you must home your machine - the post processor uses the machine co-ordinate system for safety moves. B) if you don't...
No, @Giarc is asking which post processor you are using in Fusion 360 - when you post process your toolpath in cam to create the g-code file. The...
Stepper motor fault is the least likely - you can check by taking it off the machine (and unplug the Y motor) and seeing if it runs. The usual...
Try Ratrig in Portugal - they are Openbuilds re-sellers (and have Facebook group of enthusiasts who may be able to make suggestions) and may be...
When you switched Y and Y2 was it the same side of the machine that didn't move? How much of the wiring did you switch? If it was the same side of...
It will not compensate - the probe routine has no way of "knowing" what you have done. Is the surfacing operation a completely separate job (don't...
You are correct that jogging directions refer to tool movement relative to the workpiece, so on a moving table machine Y+ will move the table...
Use the troubleshooting tab in Openbuilds Control to check that your probe is working correctly, and check the wiring to the probe for...
Which post processor are you using with Vectric? Please upload you g-code file and post a screenshot of your Vectric settings for the setup...
No, it's telling you that it doesn't like the phrase "*.cnc" - presumably a phrase that turns up in ransomware demands? Alex.
I suspect that the problem is that your spoilboard is flexing - you said in the Ratrig Facebook group that you only have it fixed to the aluminium...
Francois, How well are the edges of your spoilboard supported? Is the difference in the distance between the spindle and the spoilboard apparent...
Are you homing your machine first? - the post processor uses the machine co-ordinate system for safety moves at the start and end of the job, if...
Looks as though you have some backlash in your machine. If your pics are orientated with the Y axis vertical then the issue is in your X axis....
Please don't move stepper motors by hand if they are connected to your controller, and power off before disconnecting them. The back emf generated...
docs:software:fusion360 [OpenBuilds Documentation] Alex.
The back, right, UP corner of your machine is the MAXIMUM for each axis, but is set to ZERO in the MACHINE co-ordinate system - as you move away...
