Separate names with a comma.
Some features disabled for guests. Register Today.
You can use g-code. First raise Z to a safe height. Then send G0 X0 Y0. Then if you go to workplace zero it should just lower Z. Sorry, not...
Please upload your g-code file. G53 is the machine co-ordinate system, G54 is the first of the workplace co-ordinate systems We need to ssee what...
Great news. Alex.
Your controller thinks that a limit switch has been hit. if that hasn't happened the most likely cause is EMI (interference) - do you have any...
Depends whose motors they are - Openbuilds instructions are correct for recent steppers from Openbuilds, but there is no standard colour coding...
Not routers - the VFD converts your single phase mains to three phase and controls the speed of a three phase spindle by varying the frequency of...
No need to spend loads of money to earth the dust hose - a length of bare copper wire along the inside connected to mains earth at the Vacuum end...
Those are perfectly reasonable settings. Is it the C-beam that is deflecting or the router/spindle? Two router mounts will help the rigidity -...
What are you typically using for bit size, feedrate, spindle/router speed and depth of cut? If you push the machine too hard then you will get...
Have you looked in the builds section of the forum? 3D PRINTER BUILDS | OpenBuilds Alex.
Are you new to Fusion? The cam facilities in Fusion are much superior to Openbuilds Cam - that is a free, get you started programme and is...
As @Christian James said, this is a pretty good place to ask questions. There are also several Facebook groups (including Workbee CNC Users Group...
Did you use CONTROL > Grbl Settings > Select a machine from the list (or restore a backup if migrating from an older BlackBox) to set the machine...
Unless the tyre is damaged there's some play in the holes for the screw holding the wheel to the plates. Loosen the eccentric fully, loosen the...
Set $4 = 0 Alex.
As @Peter Van Der Walt said, and power OFF before unplugging them. Alex.
Start a new thread in the software section and upload your Fusion file so we can have a look at it. Alex.
Yes, that is correct. Alex.
As long as the back, right, up corner of your machine is the MAXIMUM dimension in the MACHINE co-ordinate system for each axis (the maximum is...
@Larry LaBonte, as @Peter Van Der Walt said, please do include some humour - but it doesn't always work in plain text - perhaps add a smiley ;):D...
