Separate names with a comma.
Some features disabled for guests. Register Today.
On BlackBox that shuts down the driver, lights up the Fault LED. Stays faulted until power cycled. OP can check it its lit
Speed, steps per mm, etc might be wrong too, it looks too fast
Has a section on doing it without a multimeter too, but if you can get someone in with a little experience that will be good
That Grbl WIki really is a must-read... [ATTACH]
Oh wait theres the problem! Get some! (: You can't use soft limits without homing. You need to Home (soft limits, machine coordinates, and a lot...
Did it move towards the switches (if not, $23 Homing dir in Grbl Settings - tell it where the switches are)
Click Here [ATTACH] To satisfy That's all
Contact the store for assistance. Thanks: Support.openbuilds.com > New ticket Include info they will request to speed up their response: Include...
I am referring to Home. Between Check Size and Wizards and Tools up top.
1) Did you home the machine prior to testing (Soft Limits applies in Machine coordinates, needs to be homed) 2) Soft Limits Enabled in Grbl...
[IMG] Extreme example, perhaps pics of yours for review would be better Yip not set correctly. Watch video below (short form, actuator are just...
Loss of position could be 1) Wiring (intermittent loss of connection from a loose terminal or damaged cable):...
BlackBox 4X is USB only BlackBox X32 is USB and Wifi Almost no Grbl controllers are ethernet 1) Go to start [OpenBuilds Documentation] > Click...
X32 has a proper 4-axes firmware yes (its a 32 bit controller running grblHAL) so not only can you leave the A-Axis connected, you can setup...
Oh I thought you meant settings. That I'd rather refer to as "toolpath parameters" - to avoid the confusion with settings Run me through how you...
What 'settings' changed?
Contact the Store via support.Openbuilds.com > for further assistance thanks
Checkout earlier discussions Search Results for Query: Sheetcam post | OpenBuilds
1) Currently correct. Any chance it was wired incorrectly before and corrected already before the pictures were taken? 2) Does the PSU start up if...
