Separate names with a comma.
Some features disabled for guests. Register Today.
Truth be told they never really did. Check in with the grblhal repo for the driver for support grblHAL, but honestly, dumping the board and...
... Spend the couple bucks and get some (:
Cam > Settings > tell it what toolhead you have
BlackBox with CONTROL will do that just fine. See https://docs.openbuilds.com/blackbox-x32 Recovering origin is as simple as rehoming. All other...
TLDR version: 1) Always Home then 2) set Zero by probing or using jog and setzero and then 3) run the job All the trouble starts when one forgets...
docs:software:lightburn [OpenBuilds Documentation] You can set the origin in the configuration to match where your machine.
Checkout docs:blackbox-x32:faq-emi [OpenBuilds Documentation]
Would still happen if its overcurrent, read the link I shared - multiple causes for fault, not just heat... Turn it down a bit
Do the test first before we jump ahead. Switch to incremental jog, do a test jog (say 100mm) and see if it lines up. Its a question, not a...
If the correct probe is selected, its sending a move like (from your screenshot) and going further: [ATTACH] Then your calibration must be off
See docs:blackbox-x32:currentadjustment [OpenBuilds Documentation] Keep an eye out, does the Fault LED for that axis light up when it stops...
As close as you feel comfortable. it only triggers once pressed, so 1-10mm whatever you are happy with.
And if you are jogging does the machine follow the correct distances and directions? If so, wrong machine profile, did you maybe change some...
Do you have the correct probe selected under Probe Type on the wizard in CONTROL?
1) Are you wired up to a compatible controller like a docs:blackbox-x32:start [OpenBuilds Documentation] 2) If not, check in with your machine...
Usb cable is unplugged? And with USB cable unplugged all the usual LEDs on BlackBox still lit?
Or incorrect taper in tool setup. Make sure angle of v bit matches angle specified in tool library
The dimensions you enter are the size it will run. So yes, determine how far it is you want to surface in each direction and enter that. Overshoot...
Reset while in motion means something shorted out the controller. Recheck probe wiring. Check that spindle body isn't shorted to DC GND as well
Make sure your gcode contains the coordinate system in its header.
