Separate names with a comma.
Some features disabled for guests. Register Today.
Install some Then HOME Then work coordinates cube will show where it actually is. Without homing machine has no idea where it is If you don't...
I think Duet's 3.3v so maybe add a level shifter to protect the Duet's GPIO
Might be best to contact the vendor you purchased from, they can provide support for their products.
Checkout ESP32/main/boards/BlackBoxX32_map.h at master ยท grblHAL/ESP32 But Pin status is available in the frontend for macros and similar already...
Yes they are used for homing. Accuracy, no official numbers, but high quality lever switches (lever increases resolution) with built in filtering...
Sounds like 3 of the 4 motor wires making contact and one loose to me. But also double check stalling due to heavy spindle, dial down acceleration...
Probably not Grbl 1.1f on that arduino. Upgrading to 1.1 will not match the pinout on the chinese clone shield.
BlackBox to VFD is just logic signals (max 10v 20mA), so Xtension Wire By the Foot will do. Standard config just sends 0-10v so 2 conductor will...
See updated docs for newer firmware: docs:interface:wifi-setup-nextgen [OpenBuilds Documentation]
Might have to do with the opening/closing of the port. Maybe your code is not doing the DTR/RTS/CTS handshakes correctly: Play around with DTR...
Correct, we just don't display it in the editor. Still loads up in 3D view and can still run it. You weren't planning on editing a 10mb file by...
You can convert some routers to have speed control with a SuperPID but its a little dangerous (mains voltages exposed - get an electrician to help...
Double check with spindle supplier, i think that should be 400 too, but not sure enough to say thats wrong.
Best to add some descriptions to those codes to help whoever has to review them (: you have the manual
If its arduino / relay modules. Lots of those relays are inverted because of bad implementation of opto coupler. Active low. No way to use those....
So when during the Does it reduce? On contact with material (VFD parameters limiting torque) or at some point later in the gcode?
Where? In CONTROL or CAM? What's the S values in your gcode?
Check out
The psu going into shutdown indicates overcurrent / short Review all wiring Especially if an older controller was damaged, before the new one is...
There's a facebook group FoxAlien Unofficial Upgrades | Day 1 of the upgrade to a 1000mm x 1000mm Masuter Pro | Facebook that might know better
