Separate names with a comma.
Some features disabled for guests. Register Today.
Pictures of all the switch wiring (switch side and controller) for review please As well as a Grbl Settings backup (CONTROL > Grbl Settings tab >...
Checkout Section 15 of Terms of Service and Rules | OpenBuilds
Grbl has one setting for both . Applies to both. Same rate up and down. Makes logical sense the mass and enertia aren't really different between...
OK well lets use CONTROL to test as we don't know or support others 1) Did you follow all the steps when setting up your BlackBox? (Didn't maybe...
Do you have $10=511 in Grbl Settings (Our machine profiles sets it for you, unless you started without a profile, or changed $10 afterwards?)
What software are you using? We don't have those in CONTROL? In CONTROL, you click Confirm Probe Position to confirm you are happy. None of our...
No, If you read that thread you'd see what you needed to do. Not REINSTALL the broken version, roll back to 1.0.376 (1.0.379 will be out soon to...
Granite/marble Kitchen countertops usually just gets a couple dabs of silicon to stop them sliding and the weight does the rest (:
Are you using the correct Post Processor? docs:software:vectric [OpenBuilds Documentation]
Contact the Store via support.Openbuilds.com > New Ticket and they can send out a fan for you.
VFD spindle? Lights up all the time or only when magnet is clipped to collet? Wired as per httpsdocs.openbuilds.com/xyzprobe correctly?
See V1.0378 update thanks
Individually is subjective, it is a CNC based system, and CNCs want syncronised moves to reach the destination at the right time. Theoretically...
CONTROL > Wizards and Tools > Surfacing wizard an option too (does not overshoot)
You can use Makerlinks Quad Tee Nut - MAKERLINK (10 Pack) [IMG] But do note (I can see you already accept this, just mentioning again) that the...
run the exe and install as usual
OK thanks for the feedback, roll back to V1.0.376 please Release v1.0.376 ยท OpenBuilds/OpenBuilds-CONTROL Pulled V1.0.378 from the list, we are...
Perfect, will work fine with the solution I suggested. You will have a little bit of a learning curve with Arduino if you aren't already familiar...
grblHAL not ideal for a non-CNC use case: ____ Arduino, couple switches and a library like GitHub - laurb9/StepperDriver: Arduino library for...
CONTROL cannot flash Arduino's. CONTROL is for BlackBox Motion Control System X32 Please contact the vendor you purchased from for support