Separate names with a comma.
Some features disabled for guests. Register Today.
Get busy. enjoy.
If your drivers will take it then use a 48v supply. Motors will perform more desirable than at 24v. They may get warmer though. Don't exceed your...
Those are modal. They tell Mach3 what unit to use while interperating the code. It sounds like your in mm mode trying to interpret code meant for...
Check your g20 and g21 in the code.
Does everything work okay when you manually jog the machine?
I've run mach3 on my 64bit win7 laptop through the Ethernet port. Since that is what I use for designing and programming toolpaths I have another...
The G540 is an upgrade over the TinyG and xpro. It's a great start. Ballscrew and rack and pinion seem to be the way to go. Belt isn't too bad,...
You can use 1-4 on the table, 1 or 2 on the gantry and Z. I'm using 3 on my X, 2 on my Y, 1 on Z. On X (Table) I have 2 to home each side of the...
I can't say. Since you ordered some I guess we'll find out. :) I mill it at work from time to time on a 2hp knee mill. That gives me more direct...
Haha agreed. Down here in the states we're stuck with both. I'm fairly well versed in either myself. I just read your post and remembered when I...
I couldn't agree more Tom! The table or frame is commonly over looked and not considered until it's realized as the weakness. I think Gray is...
I'm a fan of f360. The support has been incredible on Autodesks part. Sculpt is super fun to use. I wish SW had sculpt. It would make the day job...
hey Gray, for a rough idea divide it by 25. 200mm is about 8 inches. @Bob R I have a small slab at my desk. What do you want to know about it?...
I found Paul Campbell's Mach3 videos on yt to be very helpful when I started using Mach. Joe
Use a 24VDC psu and the motors will be more lively.
Have you compared the teeth of the new belt against the old?
Very nice. Thank you for sharing.
Sounds normal for that amount of use. Clean up the rails real good with a nonabrasive cloth. Denim may work to clear up the marks. Apply a light...
Hello Cody, My initial thought on this focused on the 1amp motor rating and the fact that you have some experience with the machine. It's...
Good to hear.
