Separate names with a comma.
Some features disabled for guests. Register Today.
Personal use has no restrictions.
It depends on the job. In 95% of the cases drafts still have to be submitted to who is doing the work. The general rule that it is still up to...
Nope. Sorry.
This? [MEDIA]
Thanks. I'll take a look at it later.
Can you post the spreadsheet?
Two 2080s fastened together will offer much more than a cbeam will provide. That only matters if what you're hanging off the front has a say.
Face stock. offset stock if you didn't for facing ((interupted cuts can wreck havoc on small single points)off setting the 4 jaw once is a time...
Hey Flo, I know it's been a while, but can you run through the math with us on this one? I'm coming up with different figures. somewhere near 110N...
You got it. The fit to the bearing is important. Have one on hand to check. They should be a line fit. No slop. You might want to try fine...
Yes. Keep your gantry shortest. Rotate the machine instead.
It's a bad idea. :rolleyes:
Hey John, What does mosfet tech have to do with this? Joe
Hey Leversole, I'm glad you found geckos site. A lot of handy info there. The TinyG is a nice board. Give it 24V and it'll treat you right. The...
Hey Leslie, Yes. That's correct. There are separate motor drivers and control board/breakout board (BOB). These are parallel port boards...
You can drag the sketch around but you can't see the profile you are dragging in relation to other parts. Not a huge deal, but in Adams initial...
Weldment is another way to build. It doesn't offer the drag and size that you were looking for. I use weldments quite a bit at work. Solidworks...
Yes. Oscilloscope. I'm not that electrically savvy unlike some of the other members, but I believe you would check the coils of each motor for...
Swap the wiring to the two motor drivers and see if the lag occurs at the other motor. The driver pots do have to be tuned to within each other....
I think ethanol fumes and brushed routers would be dangerous Dave.
