Separate names with a comma.
Some features disabled for guests. Register Today.
Yeah the 1/4 will not work for this tool path. The lines are too close and they cross with the 1/4”. Thank you though
I haven’t watched the videos yet and the answer may be in them but what formula do you use to determine your feed and speed?
Your .005 per tooth are you taking the calculation with the respect to mm or inches? So single flute running at 18000 would run about 900mm per...
Okay. Thank you very much. I just ordered some single flute 1/8” endmills on Amazon. Like $16 for 10 of them so they should be good to practice...
Okay. I have one endmill left. I think it’s a straight endmill. I will try it out. What speed, feed, and doc would you recommend for cedar about...
Okay so for some reason I have broken two 1/8” endmills back to back. A 2 flute Straight endmill and a compression endmill. I am trying to make...
Every time I create a design to carve into my piece while using easel and I center the carving to material it works great on easel. Once I...
Is there a proper way to shut the machine down or do you just put your router where you want it then hit the power button on the power box?
Thank you for your help
I think I’ve got too much dust not enough “chips” I realized I was only running it at about 10,000 rpm. I am a cnc machinist for my normal job...
Okay. I’ve got the lead 1515. Just got it put together about 3 this morning.
Can somebody help me? I am trying to find out what the calculation is that is used to figure out your speed, fees, depth of cut, and plunge rate....
Sweet. Thank you
Ok so if I flip the t-nut over so that the protrusion faces the plate instead of the inner part of the rail that will be okay? I did that the...
You’re right, the store did send me an email but they aren’t answering my questions in their responses. Look man all I want to do is get this...
I’m order to get it wide enough, the tee nut is sitting on just about the last thread so if it does slide on, the tee nut pops right off. I am...
The gap between the plate and the tee nut is not wide enough to allow the tee nut to slide into the rail
I have the thread going the way I was told and it shows in the video. I CANNOT get the tee nuts to slide through the rails.
I have posted threads twice, both got taken down. I have emailed openbuilds , I got run around answers. I have been on the first 15 minutes of the...
I have recently purchased the lead 1515 fully loaded. I have been attempting to put it together. I have spent about 5 and a half hours and am only...