Separate names with a comma.
Some features disabled for guests. Register Today.
No Problem
Just had to remove the black box cover and put 4 m5 washers between the 4 fan mounting bolts and the cover. The fan for no reason flexed and...
Flashed firmware and still does not work as intended. Probe set up according to diagram in Probe wizard using 3.2mm endmill. Touches Z first fine...
Point On, that was it. Changed $10 from 0 to $10=511 and now shows Triggered when activated. Thanks for your speedy reply.
[ATTACH] Is there a setting to activate this test feature? All tests are green Off status and nothing I do changes the status. For instance the...
Update, there was a calibration issue on the Z Axis Old $102 value was 50,059 had to change to 208.58. After changing and running Z Axis probe the...
Don't think it's a calibration issue, machine was used fine, carving 2d and 3d carves. Only issues were after Black Box X32 and Control Software...
Thanks, XYZ without the automatic tab selected works fine, I think. I looked at the log and G4 P0.4 is in the log. But when I hit the - Goto Z0...
Yes I am using your wizard only and only for your XYZ touch plate. Z first then X then Y and they don't get stuck, only when the bit enters the...
Thank you.
Are these photo's what you needed? Know you are busy and hate to bother.
I think this is it.
Firmware is up to date. Still ran the flash utility and still same results as posted above. Tried to get video off IPhone but too big and need to...
X32
Control software V1.0.344, when probing with Openbuilds XYZ probe and setting the bit just over the hole it moves and sets the Z then moves and...
Yes did hit disconnect in Control software and Lightburn to my knowledge doesn't have a connect button, it must connect on start up. I'll...
Ok, Control Software [m3 s250] Lightburn Software [m3 G1 F100 S200] Also interesting, after using Control Software, Lightburn will not make a...
25% in control software is much brighter than 20% in Lightburn. I'm sorry but I don't know the process for checking any logs in either of the...
OK hashing things out with the Lightburn Forum and we came up with my old controller $30 was 255 and Blackbox should be 1000 so I changed the...
Here are some screen shots I sent to Lightburn Forum. going to be away from shop for a while but will check back in later. Thanks.
