Separate names with a comma.
Some features disabled for guests. Register Today.
To remove the Z axis (unless it's a very recent workbee from Ooznest) you will have to dismantle the X axis gantry plates - remove all the wheels...
Have you tried loosening the screw holding that wheel and pushing it towards the extrusion as you re-tighten it? There's a small amount of play in...
We need a bit more info - what is your full electronics setup? I know you have an Arduino, but what stepper drivers? What power supply? Have you...
If you use masking tape and superglue to hold the workpiece then you won't need tabs. Alex.
Only "cut down" in the sense that it is limited to two layers. Double sided PCB's is the limit of my aspirations so I'm fine with that. Alex.
G54 doesn't tell the machine to home - it tells grbl which (the first one) of the 6 available WORKPLACE coordinates systems you are going to use....
Eagle is built into Fusion (a cut down version if you have the personal use license for Fusion) Alex.
Not familiar with that machine, but it uses grbl 1.1 firmware. Error 9 doesn't tell us what the problem is - there would have been more details...
What version of Aspire was that created in? Is it a legal copy? I cannot open it. Alex.
One more test - by swapping the connectors at the blackbox end you were using the same cable - try using a different cable between the blackbox...
Wiring can be fine - until it's not. Vibration can shake connections loose, constant flexing of wires can break them - sometimes inside the...
If you have them set at the Openbuilds defaults (2500 mm/min I believe) you could probably go a bit faster - increase them gradually until you get...
Error 9 doesn't say what caused the error - something preceded that error message which tells you what the cause was. Does your control software...
Look at 1.5 Kw spindles. 2.2 Kw is nearly 3 Horse power - way overkill for a machine based on aluminium extrusions. I have the RoutER11 -...
[ATTACH]
In Vectric - toolpath tab - setup there are settings for safe Z - you particularly need to look at what Vectric call the "home/start" position -...
If you are using a blackbox (or other grbl controller) what cad/cam software are you using? If you are using Vectric or Fusion software the link...
I know you said you checked the connections, but that really is a typical symptom of one poor connection out of the four . Check that you haven't...
If you post your V-carve file and g-code file we could have a look at them to see what the issue might be (tomorrow in my case as it's nearly bed...
Obvious question, but did you home your machine before setting the workplace coordinates system zero (set XYZ), and did you set the workplace zero...
